Viewing all customer Discussions for:

Weatherization

I need the Bubble Window Strip on the Bottom of the window in White 519 inches of it. I also need the wool pile weather strip in with or gray 1526 in of it. I do believe it is 3/16

please advise me for some replacement weather strip about 7 feet long, fits into a slot in the door jam. see picture attached Also how do you remove the old seal and then install the new one. Does it just pull out or must you remove the jam and slide the new piece in. And then how do you remov ... (cont.)

I need push in weatherstrip like code 58-173 but mine is rubber not vinyl. Can You help?

I have Milgard casement windows using the window gasket illustrated in the attached image. If you produce this configuration, I would like to know cost, color options, and if you have any type of installation guide. Manuel G.

I need to replace wool pile strips in sliding windows. I checked the existing strips, and the ones on the top and bottom sliding sides have fins, and the ones on the right and left sides don't. Was that done on purpose and has to be followed, or one kind of wool pile for all sides should be fine? ... (cont.)

It is V shaped 1/8 inch It is 13/16 in width from top to bottom It is black and it is 36 inches in length. Can you find me one light that. I had ordered 58-162 but it is to short in width. It was a custom screen door with no marking of a maker on the door. Thanks for all you help. ... (cont.)

I need to replace weatherstripping on about 12 Pozzi wood casement windows - 1979-80 vintage. Photo of end of a strip with dimensions (1/4 in on one leg and 3/8 in on the other leg. is attached. Please let me know if you have stripping like this and cost and delivery info. Thanks, Jeff ... (cont.)

As you can see from the picture, my fuzzy pile is no longer very fuzzy. :-( The attached pictures are of the aluminum frame of my 1968 VW camper. I need to replace the pile so the windows a) stop rattling, and b) stop leaking. Both important, be b is the greater need. If you look end on to ... (cont.)

I need 3 32" lengths of the weather stripping featured in the attached pictures. Can you help?

I have been able to identify the Stanley imprint on the hinges of the patio door at my sons' house. The door is wood interior and metal exterior. The weather stripping on the metal threshold has deteriorated and vacated. I cannot find any other markings any where on the door to identify it further. ... (cont.)

This weather seal slides into a channel on the front face of the window (Mfg = unknown). When installed correctly, the seal is formed by the foam filled tube section of the weather strip. The piece measures about 3/4" inch from top to bottom and about 5/8" from front to back. the bit that fits into ... (cont.)

Will 58-008 prime door seal set/weather stripping kit work on a Therma Tru entry door?

This is off a old weather shield wood casement window, the two fingers go into the sash, then there is a bulb on the opposite side thanks for yur help!

58-171?

Need help locating this weather stripping for my in swing door. Thank you !

Hello, I want to make sure I am ordering the correct part for my door. Presently there is magnetic weatherstripping on the right and top sides of the door. Please see enclosed pics. Do you have this in white? The length I need is approximately 79" for the right side as that piece is tearing from exc ... (cont.)

I matched part #58-164 to my window fairly easy. Can i use part # 58-171? The peice that slips into a pre-existing groove in the sash on part 58-164 is 3/16" and 5/8" over all in height. Part 58-171 is in 100 th. measurements. Part 171 has a Foam Filled Bulb is that better than 164 vitch is ... (cont.)

Hi, Looking for a window seal or glazing product. Have sliding wood windows and this seal is in the permanent window where the other window overlaps when shut. Thanks for your help

I have a 3 glass Marvin casement window that is 37 years old. The window wood and glass are in good condition , but the weather-stripping in not sealing. Is your product #58-053 (White) a replacement for my Marvin casement window?

I am trying to replace the weather stripping in my windows. I believe they are MW circa 2001. The measurements are as close as I can get. The piece is pretty mangled. Thank you