Viewing all customer Discussions for:

Weatherization

Trying to match replacement stripping on a 15 year nuair window. Looks like 3/8" "T" type groove figment. What is your opinion. Photo upload didn't work from my old iPad. Sorry

Need to purchase several sticks

I am looking for Pella glass door end seal

Where can I get this bubble weather stripping? I need about 100 feet. This came off an unknown brand aluminium storefront door thanks

I need approx 20 feet of glass beading to repair 2 Cascade sliding doors

Hi, Can you tell me if you have something similar to this tan Pella beading.

Older aluminum sash windows need some new hardware. Would like your recommendation on replacement. Pictures attached. Plastic glazing bead strip. In folded position as taken out of window, the strip measures 13/16", fold over a 1/4". Mohair strip insulation, track opening from outside is 1/8". ... (cont.)

Hi, I am trying to find a replacement for my old cracking window gasket. Any ideea what woul be the closest replacement? Thank you The U shape wraps around a piece of wood with the bubble on the side.

Hello, I am looking for the glazing bead on a jeldwen vinyl patio door. The larger section is closer to 3/4. The 4 side legs that I need have to be a minimum 74" let me know what you find out.

chamber covers they fit on each side of the door

I am adding photos of out bay window and weather stripping that is disintegrating. Also damage coming to woodwork inside. I have tried Home Depot and have been searching the internet for a similar stripping with no luck so far. We will use a water proof tape to seal it up for the winter. I need abo ... (cont.)

I am looking to replace a 1/4" x 1/2" rubber seal at the bottom of a Harvey window. It's very degraded in the pictures.

Hi, looking for part to replace bottom of door were the door sweep is. Looks like it is unit and not just the rubber. Markings on are: PPC Herculite Trempe Tempered. CAN/CGSB 12.1 m. BS 6206-198IV. 16CFR 1201. ANSI 2-97.1 1984 SGCC 1065. If measured correctly dimensions are. 1 1/2 x 35. 2'11 ... (cont.)

Hello, we have double hung wood windows by weather shield that were installed in 2006. I need weatherstripping to replace that in the photos. It fits in a groove on the bottom of the lower sash. The foam filled part is approximately 0.5", and the plastic insert is about 7/32" or 1/4". It looks a ... (cont.)

I am trying to replace my window pile. Wanting to make sure the size. Please advise. Also need for the screen. Thank you

Pella windows are very leaky between the sashes...they are wood windows (aluminum clad). would like to reduce the breeze in my house. :)

I have Weathershield French doors that need the weather striping replaced and need to know what to replace it with as I have not found anything that is similar. I have attached pictures with sizing as instructed and await you recommendation. Thank you. Ted

Need to replace this part

I have been unsuccessful in finding a serial number on the sliding patio door but I was able to photo the Pella stamp located close to the handle. I purchased a house in 1998, it was built in 1955. In the 1980' a remodel was done to the house in which the patio door was installed. Just trying to fi ... (cont.)

Hi. I'm looking to replace bubble seals on 20-year-old double-hung wooden windows. The bubble diameter of the old material is 1/4 in., and the base extension is also 1/4 in. (See photo.) I'm trying to get a tight seal on gaps that run along the bottom of the lower sash and top of the upper sash. ... (cont.)