Viewing all customer Discussions for:

Weatherization

Hi, I am trying to find a replacement for my old cracking window gasket. Any ideea what woul be the closest replacement? Thank you The U shape wraps around a piece of wood with the bubble on the side.

Hello, I am looking for the glazing bead on a jeldwen vinyl patio door. The larger section is closer to 3/4. The 4 side legs that I need have to be a minimum 74" let me know what you find out.

chamber covers they fit on each side of the door

I am adding photos of out bay window and weather stripping that is disintegrating. Also damage coming to woodwork inside. I have tried Home Depot and have been searching the internet for a similar stripping with no luck so far. We will use a water proof tape to seal it up for the winter. I need abo ... (cont.)

I am looking to replace a 1/4" x 1/2" rubber seal at the bottom of a Harvey window. It's very degraded in the pictures.

Hi, looking for part to replace bottom of door were the door sweep is. Looks like it is unit and not just the rubber. Markings on are: PPC Herculite Trempe Tempered. CAN/CGSB 12.1 m. BS 6206-198IV. 16CFR 1201. ANSI 2-97.1 1984 SGCC 1065. If measured correctly dimensions are. 1 1/2 x 35. 2'11 ... (cont.)

Hello, we have double hung wood windows by weather shield that were installed in 2006. I need weatherstripping to replace that in the photos. It fits in a groove on the bottom of the lower sash. The foam filled part is approximately 0.5", and the plastic insert is about 7/32" or 1/4". It looks a ... (cont.)

I am trying to replace my window pile. Wanting to make sure the size. Please advise. Also need for the screen. Thank you

Pella windows are very leaky between the sashes...they are wood windows (aluminum clad). would like to reduce the breeze in my house. :)

I have Weathershield French doors that need the weather striping replaced and need to know what to replace it with as I have not found anything that is similar. I have attached pictures with sizing as instructed and await you recommendation. Thank you. Ted

Need to replace this part

I have been unsuccessful in finding a serial number on the sliding patio door but I was able to photo the Pella stamp located close to the handle. I purchased a house in 1998, it was built in 1955. In the 1980' a remodel was done to the house in which the patio door was installed. Just trying to fi ... (cont.)

Hi. I'm looking to replace bubble seals on 20-year-old double-hung wooden windows. The bubble diameter of the old material is 1/4 in., and the base extension is also 1/4 in. (See photo.) I'm trying to get a tight seal on gaps that run along the bottom of the lower sash and top of the upper sash. ... (cont.)

No question but comment. Our 20 yr old Andersen 200 series tilt wash bottom seals are failing. The kerf 5/16 bubble seal are a perfect replacement! Highly recommended.

Can you identify this part? Also, how is it attached - screws, glue, staples, etc.?

Looking to replace pile and bubble weather stripping on a window. Approximately 24x37.

Hi: This is on the bottom, and is a guide / seal retainer for the the bottom of the door. Can you tell me what it is actually called and what if any my replacement options are? Thank You!

Hello Swisscom, I am looking for two pieces of white vinyl snap trine for a white vinyl double pane sliding glass door. The first piece is 45.5 inches and the second is 74 inches. The inside sash of the door says ,' Series 8500 AAMA/I.S. 2-97 SGD-C30- 96x96.

Having problems locating this piece of glazing vinyl, was told it was Jeldwen

Hi, Need weatherstripping for Milgard vinyl windows (probably installed 1999-2000). Measured the width of the bottom strip, and it's 3/16". More difficult to measure the height, but I'm guessing about 3/16" as well. It's grey colored, wool/pile..I guess. Can you help with a few suggestions ? Than ... (cont.)