Viewing all customer Discussions for:

39-140 Dual Arm Crank, 16"

not sure if I need to buy the whole assembly as it is just the lever that broke in the center part. the window is from Jen weld Co.looking for center section of the arm assembly.

No markings. The arms are manufactured bent similar to 39-393. Extended out the arms total about 12"

I am looking for a window operator replacement with the same dimensions for re-installation.

building from 1992 and I think these are original. I have three windows where the crank mechanism has failed.

Hi,Following up on our phone conversation yesterday, I have attached additional photos of the operator linkage assembly.Could you please forward the submittals for the operator that you provide?Best regards,Steven

Crank operator screw came out of housing and will not thread back in.

See attached

Manufacturer: Truth

BIU

if I can get away with it, I was just like to replace the rotary gear and handle. However, if I need to replace the whole awning operator, I will. The way that they have this installed I would have to remove the bottom sach of the window.. However, I'm not sure what part number this is. It could be ... (cont.)

I have a large window with 6 smaller windows framing it, 3 on each side. The six smaller windows are all awning type windows. One of the six has a broke crank housing - it does not conain the worm gear and it backs itself out when attempting to close the window. I am looking for a replacement window ... (cont.)

please indetifi parts

I need a replacement window operator for this Hurd window. The current one is stripped out. The crank will open the windows but you have to press on it from outside the house to close. I can fix about anything with a good YouTube video to follow.

I have 3 casement windows customer wants new cranks for. Then have 2 larger crankout windows he wants new cranks and arms for. Believe all are anderson

Does anyone know what model this might be. I found similar ones but theyre not the same color/material but they do look similar. Thank you.

Hello, This is a bronze colored 21 1/2' awning window operator with Truth 45002 stamped in the housing. I have your 39-083 in my cart which I believe is the correct replacement. Please confirm, thank you.

The windows are about 30 yrs old . Windows are fine but won't crank out anymore. Hardware is too rusted to see any markings.

Hi the crank assembly of this Donat flamand df1100a has cracked on me. I can't seem to identify the crank assembly I need to replace it. Can you help me?

The window will crank open but when you crank to close the handle unscrews and comes off. The handle is stamped as Craftline with a numner 45054 which may be a part number. The manufacturer no longer exists.

I've a Hurd awning window. The glass in it is 17 x 17 inches. The crank handle is stripped inside the operator. The hole the crank operator goes into is 4 3/4 inches wide and the operator itself is 5 inches wide on the outside. When the window is open full way, the crank arms are about 11 inches lon ... (cont.)