Viewing all customer Discussions for:

55-008 3' WT Snap-in

1/2 inch wide

Hi I’m looking for a snap glazing bead aluminum 3/4” black

Do you have this one? Mine is aluminum however bright white plactic is ok too

I need to acquire the proper snap in vinyl window seal

Hi there - this is window glazing for an aluminum window. It is a bit of an odd shape that I can't find online no matter how hard I look. Measurements are approximate as I can't get the best measurement on sun an odd shape. I need a replacement part but can't identify it or find it anywhere online. ... (cont.)

hi, please review the attached pictures of my original snap-in glazing; will 55-006 work as a replacement? Thanks, jeff

We have a 40 year old house in Orlando, Florida. The black glazing on some of our windows needs to be replaced. It looks like 55-008. I am sending you a close up of one of the sections of glazing and then a picture of the full window. What would you recommend?Thank you, Linda

Hello i have two windows that missing molding, which holds window lock closings. Basically i can not lock my windows Both windows same size, so missing 2 identiacal parts: American craftsmen 52inc x 61.875 in 70 series low-E argon glass single hung white vinyl impact FL Lange window Model: 70 SHFL ... (cont.)

Hello, aluminum windows installed in 1960 in oklahoma city, need to replaced this glass holder , any help is appreciated, Thank youClaudio

Trying to find the attached picture glazing in Grey color

Have a 1963 Canned Ham trailer. Looking for window glazing replacement. Attached is picture and measurements. Ok with replacing with vinyl or aluminum.

Good morning, my name is Mike and I've been upgrading my windows to dual pane insulated glass inserts and want to upgrade these fixed windows too but I think I need new glazing for them. I've attached photos. Please let me know if there are certain measurements or dimensions you need.Thank you, I ap ... (cont.)

I am trying to replace vinyl window glazing on a Krest Mark Series 100 window. The picture shows how the glazing looks on the window and what the end of it looks like.Please let if you have avaiable.Thanks Brad

I need the snap=in glazing trim for an awning window. The house was built in 1957. The originl trin is aluminum. Do you have anything that I can use? I have attached pictures of the trim from 4 sides. I wwould need approximately 9 feet.....

I have a 40 year old (ish) window green house with alumimun framing and very thin glazing. Much of the snap in glazing bead is intact but some has disintegrated in the sun. Photos are attached. Can you help identifying a replacement? Thanks

I need window beading in white for a 1974 mobile home windows. Do you have anything like this, or suggestions for me? Thank you, Debbie

Looking for an equivalent bead. The bottom leg that touches the side of the pane is 3/8, this has a small amount of adhesive where it touches the side of the pane. the slanted back of the dome is also 3/8, this part touches the front side of the glass. The window pane is 1/2 wide. snaps in place. th ... (cont.)

Hello there, I've placed a few orders from you and they've really helped rejuvenate my windows! I have Pan Am windows from the mid 80's and they needed springs and other parts. I am very happy with the way it all turned out. I have another question, though. On the exterior of these windows is a t ... (cont.)

3/4 wide. 2- 1/4 legs

Can you please help me identify this vinyl snap in glazing? I previously purchased one that was 9/32 in. x 1/2 in. (see the picture) but it was too big to fit into the opening and did not have the small grove along the edge. I don't know if the small grove matters as long as it will hold the glass i ... (cont.)