Viewing all customer Discussions for:

55-071 3' Acorn Snap-in

Looking for replacement seals for MI windows

Looks like these are just push in replacements.

Hello, We are needing to replace some glazing bead in our Milgard mid-1990's vinyl windows. I believe they are Classic series. Can you please take a look at the attached photos for some help in determining what we should order? Please let me know if you should need additional information. Th ... (cont.)

Not Sure what brand of window this is

Hello, hoping you can help identify this glass stop or something that will work. Thanks!!

Hi,My house was built in 2003 in Kingman, AZ. It is a very typical single story stucco home with aluminum windows, some of which are single hung vertical opening windows and some of the smaller ones are horizontal sliders. The plastic trim is very brittle and wavy and I'd like to replace some of it. ... (cont.)

this is roughly 15/16 x 1/4"

Hello, I'm going to replace some of the glass on certain windows in my house that have failed. They are vinyl windows and there are no markings or stickers on any of them and no identifiers on the locking mechanisms. I need glazing bead for some of them that are too brittle because of the sun. The w ... (cont.)

A stray bullet hit a customer's front window and broke the glass & retainer trim piece. It's the thin plastic piece that holds the double-pane window in place. It just snaps in around the perimeter exterior. I've included a photo of the profile of the piece, which is just shy of one inch wide. I ... (cont.)

Need this part.

I think it might be an Alenco window but not 100% sure. I don't see anything similar on your bead glazing website page. Do you know what this is and where I can buy it?

Hello,I am searching for attached glazing bead. Thank you for any help you can provide.

Photos should help you identify

Do you have a bead that matches this profile? The window is a Certainteed.My name is Tim with Anaheim Glass

I need a flat type glazing bead for a single pace glass application

Please advise if this window stop is available. Depth is about 2/16 which will go into the window to keep glass pushed in.

Hello, hoping you can identify this glass stop.

This glazing bead is for M I window Series 480/680. It is 15/16" wide with offset of 7?32" & a 90 degree piece that is 11/16". Hope photos help.

Hello There, I am reaching out to see if you supply the photo's I have attached for glass stops? If you need more photos please let me know. Thank you Shauna

Looking for this glass stop - width is approx. 15/16".