Viewing all customer Discussions for:

55-080 3' Snap-in

I can not find this glazing bead anywhere in the 3/4x3/4 dimensions. Do you have anything that will fit?

Curved portion of existing glaze is 17/32 inch. Straight portion that snaps into frame is 16/32". Locking lip is spaced 1/8" lower than corner edge. White vinyl glaze is brittle from sun and weather. Champion window frame i is 2002 year built in Perry home in Houston Texas. Please tell me what you s ... (cont.)

Sticker on window says 'Swisco'. Measurements of glazing material: smooth side - 11/16" side with jut-out - 3/4" distance to jut-out - 3/32"

Its 11/16 x 11/16 found one close but one side is a little smaller 55-197 is the only thing I seen that is close to what I have please advise.

I am trying to find this glazing bead. I believe it is from a HR or crestway window. I also need help identifying the color. Please let me know if you have anything that is a match. Thanks Blane

Need to source replacement snap in vinyl glazing bead. Didn't see this one on your site but the glazing bead is about 15 years old . Let me know what you would recommend Thanks Steve

Glazing bead looks like 55-197 but your other side is 3/8 ( The one that snaps in) and mine is 11/16. It is actually 11/16 on each side. Do you have same as I do?

We are having trouble locating this molding. Can you please help!

I'm trying to locate replacement vinyl glazing bead for several windows Any assistance you can provide would be appreciated. Joe

I found the attached locally but cant verify the shelf dimensions. The other dimensions check good.Do you have anything similar to the attached? Thanks!

Alenco vinyl window snap-in that doesn't match 55-174?

Double-hung wood windows from LP in 1978. Looking for glazing bead that is 5/8" on both sides. The two small lips are each 1/8 inch. The angle is probably 60 degrees (upside-down vee), but might have been closer to 90 degrees when new. Cannot tell. Do you have this in stock -- or suggestions wh ... (cont.)

I need help identifying and finding a replacement plastic window glazing part. Curved exterior side is 1/2". Part that goes into window frame is 10/16" wide and the little bead piece on the window side is 9/16" from the inside bottom. It is a white trim piece. Thanks for your assistance ... (cont.)

Would you have this vinyl beading? I see you have a profile that is close...but mine is a bit larger. Thank you, Steve

Can you please help me identify what molding i would need to replace old glazing. Measurements appear to be 11/16 inchs wide by 1/2 deep with a groove on top side. mike

WE HAD A HUGE HAILSTORM IN TEXAS AND MY GLAZING GOT DAMAGED. WILL NEED AT LEAST 70 LINEAR FEET.CAN YOU HELP ME PUT IN THE CORRECT ORDER AND WHEN CAN YOU SHIP AFTER I PUT IN THE ORDER? MAKE IS ALENCO. DO YOU HAVE ANY REPS IN SAN ANTONIO? ALEX

hi my name is carlos I need to buy this vinyl molding for window one size is 5/8 wide the other size is 3/4 wide

Hello...thank you for taking the time to help me identify this glazing. There are no markings at all, and the house is approximately 23 years old. I have attached two pictures- one with the actual material and dimensions, and the other with where it was removed. I have about 7 windows I need to repl ... (cont.)

One size is 5/8 longer size is 3/4

Please see attached photos of glazing for our Alenco dual pane single hung windows. The glazing has cracked on several windows so we would like to replace before putting the house on the market.