Viewing all customer Discussions for:

26-243A Tilt Window Latch, Left Hand

I need some window parts. To me the balance looks the same. This window is a little different than the others. It's curved at the top, but it's the only one with a label. Can you help with this?

Do you have the replacement part pictured for simonton window?

Broken latches causes windows to tilt if not locked

This is a right tilt latch. I need to know both right and left identifications please.

Looking for the small part that slides in to allow you to tilt the window in. It goes on the top of the bottom window.

I don't know the name of this part. Both broken,

Need to replace these side latches for this window

Hello, Do you have any replacements that may match these? Thank you

Hello, I have double hung sash windows, circa the 15 years old. The tilt latches need replacing in many of the windows. The parts slide in, snap in easily. i have included ruler scale on the photos. i believe these windows could be Andersen? Thank you for your time.

Hello! I need to order some replacement parts for a Simonton window from the early 2000s. Unfortunately, I can see no identifying marks on the existing parts. Is it possible to tell which replacements would be needed for the pivot shoe (or whole balancer assembly) and tilt latch from these pictures? ... (cont.)

I see it says pair and each which is it please

I need help identifying the tilt in latch. It is mounted in the window, not a surface mount. Please help.

I need a pair of an unknown brand of Tilt Latchs, with tilt latch finger levers. Attached are photos of the broken one. It has a 2 5/8” housing length, and is 11/16” wide. It has a “75” marked on the housing. The tilt latch finger lever is 1 3/8” by 7/16” deep. ... (cont.)

Can you help me identify a replacement latch for these windows? I measured them to be roughly 2-5/8" in length.

I have double hung tilt windows that were installed in 2002 or 2003. Parts are starting to fail and need the tilt latches and other parts as well.

I'm a builder/developer/landlord in need of 2 coil counter balances for a vinyl window, 2 stops (? - is that what they're called), 2 pair of the toe tabs (at the top of the sash enabling the sash removal). I also need the same nsulation strip that run along the side of the window in the track ... (cont.)

Replacing a broken window latch

Please give me the best parts to keep this window up as we open it.

i need 4 of these. it is a tilt latch on a single hung window

I have Quaker Manchester double hung windows most of them don't hold theirselves up anymore the plastic pivot pieces are broke and can't find the parts for them