Viewing all customer Discussions for:

58-055 9/32" Bubble Seal With Angled Base, 25ft

Hi,We need to obtain the attached materials to retrofit some Vetter windows. Any help you can provide will be greatly appreciated.Thank you very much,Bruce

Hello can't find seals that match on your website can you help locate them, not sure of brand of these casement windows but will need about 120 ft. Thank you

Looking for this weather stripping used in the French patio doors I have. The bottom weather stripping looks similar but is attached to a 1" plastic piece that is screwed down to the sill plate.

end profile 3/8" width 1/4"

Slider is 5/16" Foam enclosed in rubber with slider is 10/16"

top seal of the eagle door

341 and 343 are photos of the left side of the eagle (350) door seal 345 and 346 are photos of the right side seal 350 is a photo of the door

I purchased a home last year and l have 6 turn out windows that work great but need to have the outside window seals replaced. They appear to slide into a channeling. The window number is JEL-N-306. Any help would be appreciated.Brian

Need a lot of replacement weatherseals for jeld-wen windows that were installed (I think) around 2006. Thank you

I need to replace these seals Please help Thank you

Looking for replacement part

Looking for replacement seals for my Caradco double hung windows. It's hard to find anything close to that bottom rail seal. Please help! Thanks David

This window weather stripping is 32" long (obviously cut from a roll) and 1/4" tall with two angled fins/barbs and a 1/4" foam filled round core. I show a picture of the profile above.

For Jeld-Wen casement windows. Width is 9/16".

The measure is centimeters. We need 440'. Can we replace the exact one? Or do we need to find similar?

Please see picture. Not sure of who manufactured the door but we have two of them and these seals go up the vertical edges

kerf depth is 5/16 is 90 degrees to the seal the other end was v shaped and broke off but is about 3/16 gap between the window and the frame. for windows with mfr code LN-1 series clad casement aama 101/IS 2-97 C-LC60-37x77 C-LC65-33x73 i was assuming the 9/32 angled base bubble seal would fit. ... (cont.)

This is from a French door from about the year 2000. We will need about 30' of it in brown or bronze. Could you direct me to the best option for this replacement?

Install date 2000. Is there an equivalent?

It looks like the 9/32" Bubble Seal With Angled Base is the right replacement for my windows. Is that what you see as well?