Viewing all customer Discussions for:

80-106 6' Sliding Glass Door Track

My sliding door is made up of 2 glass panels that are in total about a size of 96"x 96". My tracks are bent, I need to repair the floor tracks and the ball bearings inside. I am not sure what type of ball bearing is inside. It also needs a new handle with a lock. Ive attached any markings on the do ... (cont.)

Hi I have a Wasco Patio sliding door and I need to replace the handle and also the metal piece that allows the door to slide. Thank you

I need 2 new rollers and new 6 foot track (80-102). Attached are pics of the rollers, if you could please help me identify what part number they are. Thanks

Hi Casey, I have the same problem as A handy person from Seaford. The track is bending over and has separated from the base. The 80-106 is an extruded profile with the rail being part of the profile. Is the 80-106 compatible with a SGD-C30-96x96 sliding door? Also, please recommend a door roller ... (cont.)

I have attached the bottom section of the Door which needs to track and was told that with a photo you may be able to assist in identifying the track which will fit the door. Thank you for all your help in advance and hope to hear from you soon.

Milgard sliding door.

Hello, I am look for the black vinyl door track shown in picture 1. Picture 2 list the model series - ADL 550;650 Thank you!!

Hello. My track rail has bent and is falling over under the weight of the glass door. The picture without a finger in it is an identical sliding door that has a better design with plastic surrounding the rail to prevent it from falling over/twisting. I would love to find a duplicate to replace the b ... (cont.)

Our 1600 Series SGD glass door does not open and it appears the plastic strip at the bottom came away from the end and looks buckled. Can you ID this part and can you help me locate it? Thank you!

Hi, My sliding door track is bent and the door doesn't open or close easily. Is there replacement part available?

I need to replace a patio door track, please let me know what parts to order for this.

Want new track and rollers for door

Vynil/plastic spine that the door slides on has broken away from the base track and door can no longer slide. There are no manufacturers markings anywhere to be found. The thermal pane door glass has the IGMAC stamp on it. So, perhaps the door was made in Canada. Is there a replacement for the trac ... (cont.)

I wrote already in another portion of your site. This is a triple wide (12') It is falling out of the track, which is quite smashed. I need to replace the 8' track and possibly the roller.

Hello everyone I need some help with some parts for a sliding door if you could take a look at these photos and I'll be needing the strike for that double motors lock and I want track that can go down into the track part you'll see in the picture

I am looking for a replacement bottom rail for a 6' Milgard sliding glass door

I need a patio door track, and hope you can help me with identifying the manufacturer of the door. I have over every part of the door for a name or number, but cannot find anything to help identify the manufacturer.Thanks for your help!Danny

Body is 1" tall, 3-1/16" long, 11/16" wide, and wheels (double) are 1-1/4" diameter, made of metal. Door is a Pella and approximately 18 years old

The plastic/silicone strip I'm looking to replace goes on top of the metal ridge (that the door wheels run along) located in the bottom door track.

This door was purchased ca. 2008 from Lowes. I can't find any helpful numbers or markings on the door. I need to replace both roller assemblies and the track. I have attached photos of the parts with measurements. Thank you for your assistance.