Viewing all customer Discussions for:

81-005 Sliding Door Roller, 1-1/4" Steel BB Concave Wheel

On the sliding glass door bearing it says /DnS IND. MIAMI Edwin

I am attempting to locate a replacement part for this particular roller. The only Number located on the item is NW-012. I am unable to locate any replacement part. The door is approximately 20 yrs old and I am unable to locate any name on the door or part.

Need two replacement rollers

PART # 9-214 IF THAT IS YOUR PART # NOT SURE Could you please send me a quote on this roller replacement Thank you Kathy

Gentlemen, I purchased several of your 81-005 roller assemblies for my SGDs, replacing the original rollers in my Acorn 400 doors which were installed in 1984. The rollers fit nicely. My concern is how long I can expect them to last in our salty environment. The home is located directly on the Gulf ... (cont.)

Im looking for 10 pairs of these rollers.

Manufacturer is NDS Maimi dims are length is 2 3/8, width is 5/8, height is 1 1/8, wheel dia is 1 3/8 looking for 2 please. Thanks Mike

Attached are pictures of my hardware. I could not find an exact replacement. Could you recommend an alternative? Sincerely, Chris

in photo 1 looking at the two screw holes the hieght is 1.161 the width is .675 the tabs are .945 wide and are .287 wide in the photo with my finger the main assembly is 2.051 not including the wheel or the tab piece the wheel is 1.25 in diameter and .320 wide with a channel in the cente ... (cont.)

Roller is approximate year of 1986 Mark is 83 over 14

Hi guys. My heavy glass slider has one frozen roller wheel. There are no names, numbers or markings on the hardware or the door, but 81-005 fits the measurements you provide online exactly. The only difference I see is in the appearance of the outer structure. Please advise ASAP. I'm ready to order ... (cont.)

Hi, I just sent a mail to your customer care, maybe it was wiser to send it to you... I need to replace the Rollers of my sliding door. After much search, I found you site and probably a match in your 81-005. Measurements are approximately correct. Mentions: Allen Stevens. Woodside Corp NY ... (cont.)

Cannot find any identifying information on this very old 5 ft. slider door, but here are pictures

I'm replacing an Allen Stevens Corps Woodside NY part # 6047 roller for a sliding door. It's all metal. The exterior (which as the Allen Stevens stamp) has a number in a circle with 83 over 14 in it. The number 6047 is on the metal part on the inside that attaches to the roller itself. Do you ha ... (cont.)

Body total 2 3/8", small section in front is 3/8". Body width is 9/16 Height is 1 1/8" 1 1/4" wheel Insert tab is 1/2" down, 1/4" wide Screw hole centers 3/8 apart Cheap builder door circa 1980 I couldn't find it in catalogue Thanks You, Dennis

Do you have any rollers that would work in place of these

I need two (2) replacement rollers

do you have to take the side pcs off to install the rollers

Need both replacement parts for glass door and screen

Hi, I have an 8ft sliding door that needs the wheels replaced. I'm not sure what the wheels look like. The glass is ppg herlite k. I know that's only the glass manufacturer not the door company, but that's the only marking I could find. The door was installed in a new build construction home in 1 ... (cont.)