Viewing all customer Discussions for:

81-224 1-1/4"dia Replacement Steel Concave BB Wheel

Had to remove the bottom piece from the door and knock out the existing rollers from either end. Measurements seem to be about 3" x 1" (maybe a bit more plubs 1/16") x 11/16"

I am unable to find this part. Any assistance would be greatly appreciated Sharon Henderson Glass

I removed bottom rail of door to get to rollers, The wheel housing is approx. 2 5/8" length, 1" height, 11/16' width. The wheel was sitting approx, 1 1/4" above the housing. The wheel is approx. 1/4" wide. The wheel had the following words - Killian Toronto and Syracuse N.Y. If possible, I would li ... (cont.)

Would you have this type of roller. They are quite small. I have to remove the door frame to access these. Thanks Kevin

Do you sell these rollers?

Would u have replacement track and wheels for these doors. They're bypass doors

Greetings, The roller assembly picture attached has 1 1/4" dia. steel wheels, 5/16" width and 1/4" dia. hole. The 1 1/4" wheel repair kit that you carry, what is the weight specification for the bearings? Thank you, Mark

I am repairing two 60 year old aluminum Patio doors on my home. It is a mid century home and we want to keep the doors. The steel ball bearing rollers are 1.25 inches in Diameter. The center hole is 1/4 inch diameter. The roller is 7/16 wide, with the groove approximately 5/16 inch wide, inside ... (cont.)

What roller do I need?? Can't find right part. Thank you!

need a pair of these for an oversized patio sliding door. Probably should have taken more photos, let me know if you need more info. The door is cross town at my daughter's house so it would be a couple of days before I can take it apart again.

Need replacement parts

I am looking for such wheels

I would like to replace all the wheels on four, 4' x 6.5' mirrored closet doors. We have powdercoated the frames which now look beautiful. All we need are the wheels. The old wheels are imprinted with Product of Del Mar Eng Co Long Beach CA Pat 3,670,357 Length from wheel end to t post portrusion ... (cont.)

Dimensions: 2-3/4 long, 1-3/8 tall, 11/16 wide, 1-1/4 wheel

Im looking for two nylon rollers with an aluminum? sleeve and bearings in the center of the rollers. Its for an aluminum sliding glass door. There are no numbers located on door or frame that I have located. Thanks for any help you can provide. Brian

Your item No: 81-085 is very close to the replacement roller(s) I am trying to find for this door. The existing one is 2 3/4" long (not including the mounting tab) x 1 1/4" high x 7/16" thick. My concern is this door is VERY HEAVY and has a steel wheel with ball bearings. do you have a replacement w ... (cont.)

what is the id for pin

This Large storm door has two wheel assemblies that will need to be replaced

I have 1 wheel on a 81-154 frozen. Can the wheel be replaced or does the whole roller assembly need to be replaced?

Hello, I have a Sunseeker boat which has a sliding door mounting 4 rollers made by P.E. Del Mar - P/N 3684, Model: AD1-323-LS (from their catalog). However, I am not able to find anyone who sells it and I was wondering if you could help either by pointing me out to where I can find them or if ... (cont.)