Viewing all customer Discussions for:

84-046 Screen Door Roller, Columbia

The current rollers are NOT the same dimensions as the 84-046 Screen Door Roller. They are 1" wheels with steel ball bearings in a bracket that is 1 1/4" tall, 1 3/8" wide and 5/16" thick, with 1 15/16" between screw holes.

I'm looking for 12 of these. The local home depot model is too thick. I believe they are off a Pella door, the actual door is marked, the screen is not. These are 5/16ths thick. Some look like they've been replaced, as there are some with a metal bracket, some have a screw, others are all plastic an ... (cont.)

Screen Door Rollers 1" diameter x 1/4" wide. Can't figure out how to remove it. I've tried backing adjusting screw out, screwing adjusting screw in and unit won't budge. It doesn't appear to be the type that clips on to pins in the aperture. No apparent markings

Help identifying replacement roller

The bottom metal piece that screws onto the metal frame of the screen door the screws that hold it on and the roller guides I live at the ocean everything rust

This door has rollers on top and bottom. Door installed in late '70's. Dimensions on rollers: 7/16"thick, 1 1/4" tall metal frame, 1" inch diameter plastic roller, 1 3/4" mounting hole to mounting hole in metal frame. Do you have replacement rollers that will fit? If so, part number and descriptio ... (cont.)

I am having trouble with my sliding screen door. I have photos of the problem and will upload them to you. The door was made by Better-Bilt and I had it re-screened a few years ago. I have four photos and will try to upload them to you. It might take two emails to get them through but hopefully, ... (cont.)

I'm not sure which roller size this I need helpmy size is 2" from hole to hole and 1 1/4 diameter, Hope you have them I will need four of them.

replacement part

I'm looking for an exterior replacement for the roller assembly, maybe stainless housing and nylon wheel? I can't seem to find anything that comes close to matching the upper tensioner. Any help in identifying replacements for these part would be appreciated. Thanks.

I am looking for what I think are Alenco brand sliding screen door rollers. I think I have to take the frame apart to remove the old ones. I have added a photo of the installed roller. These rollers are height adjustable by a Phillips screw on the vertical side of the door. the screw is located ... (cont.)

I am in need of replacement wheels for my screen door. The holes are approximately 1 3/4" apart.

I need 4 rollers, #84-046 when they are back in stock. Do you have any handy tips for getting the old ones out ?

On your screen door roller 84-046, what is the vertical distance from the top of the yoke where the screw enters to the tab that connects to the bottom of the door and what is the width of the yoke?

1" nylon roller in nylon holder bracket. part failed after about 6 weeks. Part now tracks sideways or tilted due to too flexible bracket holding wheel. Have tried manufacture and they have no contact number for part or warranty replacement. Is there a replacement or another part that has metal brack ... (cont.)

I need a replacement for part # 8221 ASP It looks just like your part 84-026 but it is only 1" wide instead of 1-1/8" wide. I tried the 1-1/8" ones and they did not work.

I have a screen roller that looks very much like an 84083. The height of my roller is 1 1/8 inch. What is the height of the 84083? Quentin

The manufacturer is unknown. I have attached photos.

Could i get an 84-046 but with mounting holes @ 1-15/16?

Does the Screen Door Roller with Product Code 84-046 replace a roller with similar dimensions, but having a nylon bracket, rectangular roller guard (like 80-083), and no installation holes.