Viewing all customer Discussions for:

89-021D Diecast Keeper, 7/16" Deep

I'd like to replace this patio door handle with one that has a key.

I am missing the "female" part of the lock portion. Please help. I see no markings on the hardware. Thank you

Need to buy this part.

I purchased this handle set from you. I need the keeper for this lock in the picture. Please contact me with any questions or concerns. Thank you. Andy Kruschel

Looking to identify this hardware

existing door hardware does not latch. Not sure if just the hard side is all that needs to be changed or both pieces...I had ordered a replacement (not correct)Item # 82-211, it is too wide and too tall even though site said 3" x 3/4"I definitely think I need 5/8" wide and the holes at 3 9/16" appe ... (cont.)

What part number is this white door keeper...I have the mortise latch already need the door keeper

I need to replace my sliding glass patio door handle. I believe I need a Mortise Lock and Keeper - keyed, but I am unsure what the difference between an "A position" lock and a "B position" lock. Could you please tell me what part I need to order. Thanks so much!

Need replacement parts for lock and leverInside door handle says sash controls Ferndale MiAlso outside handle has 2260 Taiwan us patent 5125703 D34098Inside handle is 8.5 in long inside holes measure 4 inches measures 6 inches long and 3/4 in wide door lock 4 1/4 longFrom Pellla sliding wood doo ... (cont.)

Hello, I'm looking for a replacement part for the locking mechanism for a door (Best I can make out by reading but see picture below: CTG Tempered 18 CPA 1201 II SGCC 1804 1/8U I need the keeper part (2nd pic showing that it is broken)

I'm looking for the keeper for this latch. Don't know the name of the part.

Good Afternoon,The lock on my sliding glass door is not working. It appears that the lever is not catching on the part that is fixed. I did not remove the parts so I only included pictures of the installed parts. The info and numbers on the NAMI sticker which is attached to the top of the door ar ... (cont.)

The sliding glass door lock hatch broke off. It's a Lennar home. Not sure if that helps. I uploaded a picture of the sticker that is in the frame. Not sure if this helps.

Need:frame keeper and #1911 striker plate

can you please tell me which keeper I need ? Thank you, Robert

Hi. I am looking for the new replacement parts based on the pics I sent. Thank you

Hi, I just bought a house and the sliding door handle needs to be completely replaced and updated. Preferably with a brushed nickel finish to match the rest of the house. Also looking for a matching security lock for the back top or bottom aspect of the door given I leave town a season at a time. I ... (cont.)

Sticker on door reads: NAMI NFRC 100/200 Code: HWM SPEC:NFRC Series: 2030 SGD MST: 6080 The sliding door has the handle. The locking mechanism on the stationary door is missing.

No ID on glass slider. Only etching on glass identifies PPG Herculite K glass. Door has been painted so ID may be covered. Looking for the keeper that goes with this reach out mechanism. Keeper measures 4 inches total height. Vertical screw holes measure 3 inches. Keeper width looks to be 3/4 ... (cont.)

Need help finding a replacement lock. Believe it was an Owens Corning patio door. No markings on the lock.