Viewing all customer Discussions for:

90-005 Window Sash Lock, 2-1/4"

Hello I submitted photos of a window latch and also need a set of spring assembly's for a window . Let me know if you need additional picsRegards,Phil

The plastic pivot is broken at the screws that hold it in place. Let me know if you have the correct parts, I believe the window is a Nu-air window approx 35 inches h and approx 50 inches wide.

I need replacement window latch

House was built 2003 with these windows installed. Need new lock. The lock is about 2 3/4 in wide x 1 in.II hope you can help.

I need this

Hello,I saw one of your Q&A's and this Atrium lock looked to be the 90-005 part. I am looking also for the keeper for this lock in the photo as that is what was broken on our customer's window. Thank you!!

We need a replacement for a broken latch on a 1969 aluminum sliding window, single pane. Attached are pictures of the broken latch, an unbroken old latch on another window, and a latch that has been replaced by a previous owner. Can you recommend what replacement latch to order that looks like the r ... (cont.)

Hi, I need some replacement locks. These are the original ones. held a tape measure so you can see length and width dimensions as well as a photo of the original lock. What is the replacement part number for these. Thank you!

MI GA195 19454276.11 windowLock is broken and MI cannot supply the part. Window is about 8 years old.Can you helpBarb

I'm trying to get a replacement single hung window latch. House was built in 2005. It measures 2 1/4" inches screw hole to screw hole. There is no receptor piece on the upper window, the latch just glides under the bottom edge of the upper window to lock.

Window lock for small tilt in frame.

Recently I received 4 of 90-272 as replacement for my Masterview windows. While the 2 1/4 size for the screw holes was correct, the depth of the "lock" flange was too long by about 1/4 inch. I think I may need to order 90-005 instead, but your website does not show the flange length for either versi ... (cont.)

We think these are Amsco windows, not sure of age. The part number on the back is 10R-4. It measures 2-3/4" wide, the screw holes are 2-1/4" apart. The color is taupe.

Good night, trying to identify the weather stripping type or a viable replacement for whats pictured in the photo with the window tag. Also trying to identify whats used to make those grid lines on the window glass. All mine are brittle and break off byt touching. I need to fix 5 simillar windows. ... (cont.)

window sash lock, states honeywell international on a tag on the sash. SO# 109253-LI#4 DPH 1 vent.

I have these windows in my house that was built in 1999. Some of the windows are hard to open. I think the springs in the silver tinge in first picture are bad. Can they be replaced. The second picture is of the window lock and has manufacturer symbol on it. Third picture is a sticker inside ... (cont.)

I am looking for the bottom roller mechanism for my Atrium windows, need (6). Also I need the locking mechanism in the pic for 2 windows for some reason when I try to lock the window the piece that flips out doesn't seem to be long enough to reach the stationary window. It doesn't look like there is ... (cont.)

Please review window latch images attached. Two gapco window latches, both left and right sides are needed. 2 1/4 on center screw holes.

I have 15 windows with IWC WINDOWS THAT I'd like to replace the balance assts. the metal channel is 17" lg

Is there a replacement for the latch in the photo?