Viewing all customer Discussions for:

90-009 Window Lock, 2-1/4"

this is from an older Champion Window and I need three of these. I believe from hole to hole is 2 1/4 inches.

Hi there, thank you for your help identifying the correct replacement part. The lock is curved on one side and where the locking mechanism engages inside the window is broken clean off.

Have the Visions2000 Single Slider window and need new sash locks. Ordered Product Code 90-286 and these do not work. The locking part is a solid piece and it needs to be a hook. The size of the lock is perfect but the locking mechanism does not fit -- needs to be a curcular piece with more of a ... (cont.)

Purchaced a 1957 home, latch for small window in laundry room crumbled when attempted to use, need replacement. Says "KELLER" on top. Half circle type that you rotate to lock/unlock.

I have a few windows on my rental property that have bent or poor latches....they are the same on all windows. Please help me find a replacement so I can replace.

please identify

I need to replace this window lock. Can you identify the part number? Thank you.

Attached are some pictures for a window I need help on parts. They are for a spiral balance and the metal rod is 29 inches in length and 3/8 inches in diameter. The bracket that the spiral balance fasteners to is 1 inch wide, 1 3/4 inches long and 3/8 inches thick. The locking mechanism is 2 3/4 inc ... (cont.)

Good Afternoon, I am looking to find these window locks from 1980s, single pane windows Any help is appreciated. Thank you.

Looking for black window sash locks to replace some that are broken. My neighbors found a brand that fit (see attached photo) but she got the last few that were left at the store.

hole to hole on lock is 2 and 1/4

I'm hoping to replace the window lock/latch in the photos. I have two of them that are broken. They are a bit older and have no idenifying marks on them. Thank you.

I need to replace the same Marshall sliding window locks that customer asked about from Monterey Park in 2017. You said to look at 90-009 or 90-005 is that a Marshall lock? Are they still available? Thanks

Sash lock has a symbol that resembles a letter B

I looked at many of your sweep lock parts but can't find the exact one as shown in these pictures. Screw holes are 2-1/4" apart Main housing is 2-7/8" wide, and 7/16" deep.

I need 6 of this type

Hi, I'm looking for a replacement for this latch that was removed from a sliding screen door that is part of an overlapping set of four sliding panels that goes across a two car garage. They are edge mounted as opposed to surface mounted. Unfortunately I did not photograph them mounted but have atta ... (cont.)

2-1/4" on center screw holes x 2-7/8" long x1-5/16" wide Pics included

Hello, we need to replace the locking lever on several of our windows. The outer casing that has the screws is fine, there are just several windows where the actually lever has broken.

This latch is from an Omni window from the mid 80's.Hole to hole distance is 1.200The thickness of the lock wedge is .170Would appreciate it if you could find a replacement or substitute for it.Thanks,TomThe correct hole to hole distance is shown on the photo. it should be 2.200, not 1.200. My mista ... (cont.)