Viewing all customer Discussions for:

90-237 Face Mount Keeper, 1"

Hi - I'm searching for replacement locks for Anderson part #12895. I need 11 of them. Thanks, Tammy

This part is a face-mount window keeper

13008-1

The closest item I can find on your site is the 90-278 which is the proper 2 1/16 screw separation but the hole distance out from frame appears to be wrong judging by the photos. I am looking to order about a dozen.

Do you have the ones that match up with these holes?

This is an upper sash balance. Part number 5.737.877. The plastic part at the end of the rod is broken and does not stay in place.

1.75x 1.5 with 1 inch between hole center.

Customer brought these in Sorry don't know any info about windows at this time Can you tell what these are ? # on one of the keepers 2600-410-3

the keeper slides into the window, holes are 1" apart, from center of hole to the top is 1.5" it is also 1.5" from edge to edge. The lock holes are about 2 and 1/8 from center to center and 1/2" back to center of hole from keeper

We need the latch pictured that fits with the attached picture of the keeper. There are no markings on amy part of it.

I'm looking for widow latch keepers for my windows manufactured around 2005-2006Thank youRichard

See attached photos and let me know if you carry anything like this -- Thanks. This is for a horizontal sliding vinyl window.

Double hung windows in mobile home. Window manufacturer unknown. Keeper built into slot in bottom of upper pane.

Having a hard time finding replacement locks for a few broken ones in our new home. On the lock, the holes are 2 1/6" apart and from the holes to the edge of the lock is 1". The lock height is 1/2". The keeper holes are 1 7/8" and the closer, raised mount holes are 1" apart center to center. The ... (cont.)

Canon find any markings or numbers on hardware.

I'll have to follow up with the rest of the photos.

for double hung window in a college

Both window balances 29DS 38 window latches are broken off missing 9 balance stops

I am looking to replace one of these Cam Locks that were installed in 2019 with 3 Replacement Vinyl Windows. I posted the Cam receiver so you can see what the Cam actually engages with. I have not been able to find anything close with a 2 inch hole spacing. The screw hole set back is 11/16" which se ... (cont.)

only marking observed are two numbers on the back side of the lock. 13466 and 13467