Viewing all customer Discussions for:

90-237 Face Mount Keeper, 1"

Windows are 25 years old. Need to replace lock and latch. The pictures shown are of a working lock and latch. Simonton is the window manufacturer.

Cannot ID brand of windows. Purchased house July 2021 parts are missing and/or falling apart. 10 windows various size. 1. 2 windows are missing 1 vent latch ea. 2. 1 window missing the part to turn and lock window. 3. All windows need weather stripping replaced. Some missing most are ripped and fall ... (cont.)

I was wondering if you have something that might work? If not is there something that is close to those dimensions that I could cut shorter in height and drill new holes?

Hi, I am looking for the same double hung window keeper as this: https://www.swisco.com/discussions/Need-double-hung-window-lock-keeper-77-109153 The one recommended on that page is too small. Do you have another that will work? Thanks, Andrew

I royally hate these push button locks and would like to switch them to this style lock with an upright keeper. Any suggestions?

I was thrilled to see this opportunity to hopefully get help with my issue. I have five vinyl windows installed about 1904; I moved in last year. I have a problem locking the windows, as do, apparently, many other people in the building. The plate on the frame of the top window is a bit too far fr ... (cont.)

We have tilt windows and I need to identify the part on our windows to purchase a replacement

I am looking for this window is certaiteed

Hello, I'm looking for a help to find a replacement for my broken window lock. Any help is highly appreciated! Tank you, Matt

Window latch and lock replacement

I am looking for replacement locks for my window, it's 2 1/8 hole space on the lock and 11/16 on the backset. The backset piece needs to be flat in order to work on my window, as the thicker ones wont let the window open or close

I need to replace the face mount keeper for my Swisco white vinyl window. The part number on the back of the existing keeper is #680111. Screws are 1" on center. Height from top of keeper to bottom of keeper is 7/16". Width of the bottom is 1 1/2". Windows were installed 2006. Do you have ... (cont.)

Hello, I can't find any identifying codes on these pieces except MDO in the middle of an imprint of Texas. I think there is also the number 5 or 6 below the MDO, but it's not super clear. I've attached the "top" and "bottom" of the two pieces I need. (I need several of each.) Anyway, I can't fi ... (cont.)

Need a replacement part for the locking device on an Alcoa window.

Need help identifying a replacement part for window latch. The latch holes are 2 1/6" apart and the part it locks into the holes are 3/4" apart. Hope you can help, thank you.

Hello, I have no idea who manufactured the windows in the new home I bought, and there is no identifying information on them unfortunately. A couple of the sash keepers have broken and I cannot find any keepers that look like these with the screw area projecting from the side of the keeper. I'm hopi ... (cont.)

The tricky part here is the keeper that slides under the slot in the window frame. I ordered and then had to return a set that had the keeper on top which wouldn't allow the window to slide over it.

Need to find a replacement for this lock. It is 2 1/4' hole to hole and 1 1/4 front to back. The latch does not extend past the casing so it needs the right keeper as well.

Hello I placed order 1350465 on Feb 29 2020 for one face mount keeper , part # 90-258 . I need 5 more but I notice the part number is not listed on your web catalog .Can you suggest a replacement ? The dimensions on the piece between the screw holes is 1 1/8" and the unit is 1 3/4 " in width ( a ... (cont.)

Need to find a suitable replacement, thank you for your help!