Viewing all customer Discussions for:

90-237 Face Mount Keeper, 1"

Both window balances 29DS 38 window latches are broken off missing 9 balance stops

I am looking to replace one of these Cam Locks that were installed in 2019 with 3 Replacement Vinyl Windows. I posted the Cam receiver so you can see what the Cam actually engages with. I have not been able to find anything close with a 2 inch hole spacing. The screw hole set back is 11/16" which se ... (cont.)

only marking observed are two numbers on the back side of the lock. 13466 and 13467

Need both parts - the lock and the plate the lock part goes into. Overall The lock portion is 2 7/8" long x 1" deep

MI windows suggested that I reach out to y'all. For mi windows because these parts are no longer manufactured by MI Windows and doors. GA5500 is the window series that is installed in this house. I have one window with missing keeper or receiver. I have sent pics .Thank youEdward ... (cont.)

I believe the link below is the latch piece I need. I attached two photo's from two windows, one is broken and one is fine. https://www.swisco.com/Keeper-Face-Mount/pd/Hung_Sliding-Replacement-Sweep-Locks_Keepers/90-263 Another question - if the windows won't hold open all the way (some slide down ... (cont.)

Need replacement parts for the sliding window latches. The lock hasp is sheared off.Dimensions and arrangement is as shown in photos.Shishir

My window lock screws are a little more than 2 inches apart. They are a little less than 3/4 inch from the back, although a Swisco help agent says they don't look that far back. The screws on the other piece are 1 inch or 1 and a half inch apart.

The windows are Litehouse 437 (415) Sh white, 10/6/2003Sales order/Line: 9015233/13 Sold by Simonton. If located, I would like to order 6 pcs. Thank you, Alan

Hello, I am looking to replace broken lock, but cannot find the right one. The window is vertical slide Sash about12 years old.

Customer does not have window manufacturer info and needs new locking mechanisms for 6 windows

Windows are about 10 years old

Looking for a window latch keeper.he space between the two hole spacing is 1 1/4. Are there other possibilities?

I'm looking for replacement part. This matches your part 90-237.

The rectangular lock holder has a number 33stamped on it. 33 are needed. The lock or latch has a #4 stamped on it. 33 each are needed. Take out clips 46 ea are needed. 34 size 21" balancers are needed. 20 size 15" balancers are needed. 116 #8x counter sink stainless steel Philip head screws are nee ... (cont.)

The piece that the latch goes under has broken off on a few of my windows. Part says 2700-402

I am trying to find replacement window locks and Keeps for my home

Looking for this half of the window lock or if needed I will purchase the fulll lock.

I just need the plate

Replace broken window say lock