Viewing all customer Discussions for:

S350-17 17" Series 350 Channel Balance

Need 2 of this part. Plus 4 clips.

Looking for replacement window guides. Just bought this house, previous owner has ordered parts in the past

Length less plastic ends is 17". Marking " 1630" on metal. I am missing just one of the 4 balances on the window. Need cost and delivery time. ThanksJohn

Channel balance

1620 17" long 9/16" wide.

Part 16 D is on the old balance. Which part number would replace? Thank you

In reading a previous post here it appears that my current channel balance series convert to S380. I have (1x2) 17", (10x2) 24", and (1x2) 18". The photos included are of my 17". I believe that the bottom fitting, 15-005 looks like my current fitting. However, the top fitting, 19-005 doesn't look ... (cont.)

Need a new one

I have the 17" channel balance with a stamp of: 16 BUSB. Which weight option does this indicate?

The number that I found on this channel is 1620 Length is 17"

I am trying to figure the correct part to use as a replacement. This is 1/2" wide and is 17" long. I believe this is a S350 based on the pictures. It is stamped with 1630X, which I believe is the weight based on your catalog. Can you confirm based on the pictures.

I'm looking for the right part to match this channel balance. It is 17" long and 1/2" wide

I have a channel balance with a broken sparing and need replacement for it. The channel is marked or stamped 1620 and is on an Alcoa Window. The aluminum channel is 15 inches long with nylon ends. It looks like the S350 with what I could tell from the Photograph. The House was built in 1980 with dou ... (cont.)

window balance parts identification

Trying to figure out which model would work for my application. 1/2 inch wide, 17 inches long, marked 1620F Thanks

Hello, searching for parts for nuprime windows the block and tackle are 1620 on two Windows that measure about 3x3 feet and do not know the block and tackle number on the third one that measures about 3feet wide and 4feet tall. Also, need three locks with a center to center hole of 1 1/4 inches ... (cont.)

Need a couple channel balances for a non-tilt window. The channel (#1620) is 17" long and I am including pictures of the shoe & top. The channel is 9/16" wide x 5/8" deep. The shoe is 15/16" wide from the outside of one ear to the outside of the other ear and 1-1/16" from the jam liner side of ... (cont.)

First, measure the metal part only, this will determine the balance length. Then, give us any numbers printed on the balance. Last, take a look at the balance shoes (attachments) and see if you can match them to a set Swisco carries (this will determine the balance series).