Viewing all customer Discussions for:

23-011 Door Roller, 1/4" offset, Front

Do you have these parts? Not sure what the offset is for the front and rear.

I've been looking at many sites to try and find a replacement part of this. I suspect it was intend to be used as a top hanger part but is on the bottom of the door and runs in a track on the floor. Any ideas? Thank you.

I need 4 mounting hardwares with 8 screws. Markings, To adjust loosen screws half turn. A shows top. STERLINGThe hardware measures...2 7/8" x 1 5/8" The roller measures 3/4"

i tried your i'm afraid i've got bad news it doesn't fit but soooo close. everything but the wheel size is correct wheel should be 3/4 not 7/8 my father used to sell sterling for very long time and we know now that it's supposed to have the smaller wheel size.

One marked A is 1/4" offset and the other one marked B is 1/2" offset

Am trying to find instructions for how to use the "adjustment screw." Turning the screw is difficult & it is unclear that it even has any effect. Need very basic info on what "adjustments (e.g., direction?; distance?)" can be made with the adjustment screw, does the door have to be removed from the ... (cont.)

Looking for this roller or suitable alternative.

I think 23-011 is exactly what just wore out on my wife's closet door but 23-012 looks very similar. What is difference between "front" vs "back" in descriptions? Thanks.

Need to replace pair. Original manufacturer is "Sterling". Patent number stamped on part is 2,999,267. Thank you

Hello! Do you sell a closet door roller like the ones pictured? The wheel is smaller than what I can find at Home Depot and Lowe's. The graph paper is 4 squares/inch. Please let me know if you need anything else. Thanks, Peggy

We have Lawrence Brothers bypass door hangers on our bedroom closet. On of the hangers broke. A trip to the local hardware store came up empty. They had a similar hanger however it has a flat-edged wheel. Ours has a rounded edge and the new one would not fit in the track.I was wondering if the 23-04 ... (cont.)

product 23-011 looks like what i need but the hole deminison I have is 1 5/8 not 1 1/4 do you have one the size I am looking for. thanks John