Viewing all customer Discussions for:

23-048 Kenna Track Rear Closet Door Hanger, 3/8" offset

Not sure about offset? Measure from counter to bend in bracket, not counting wheel is 1/2" is this something you sell? And if so please give part number. Thanks

Hi - I purchased 8 kenna track closet door hangers and received today. Unfortunately they don't fit the track - the wheels are wider and thicker than the ones I need to replace.The old ones have a wheel with width 3/16" and diameter 3/4". The new ones have width 1/4" and diameter 7/8". Can you hel ... (cont.)

On the wheel it says Scottie Kennatrack and on the back it says Kennatrack Elkhart

Please help identify this part for purchase of a replacement

Looking for these

I noticed that the Kenna Track Front Closet Door Hangers in one of my closets are offset (pictured) while the others are not. The offset causes the doors to rub together and is pretty annoying. Are there any equivalent pieces without an offset that I could replace this with?

Hello, I have older door mounts that I am looking to replace. Dimensions: 1" wheel, 3 1/8" height, and 1" width. Offset: 1/8" and 1/2" respectively. Please let me know if you have anything available or where I can purchase those mounts. Thank you. Bob

I need to replace a wheel for the roller in the attached photos

looking for replacement 1959 home. closet bypass doors. I believe these are 3/8 offset 7/8" rollers. all the ones I found locally do not work. drags on bottom

Need replacement assembly.

I have KennaTrack rear closet sliding door roller with a broken roller. Front-3/4 and Rear-1 3/8. What is the replacement part? Thanks, Paul

I am looking for a pr 3/8" offset rollers with a 7/8" o.d.wheels with a shoulder as shown in the attached photos, do you have any that would match? Thank You

Hi, please see the attached photo. I'm in need of the tear-drop shaped piece. Sorry, I have no idea what it is called.

I have an old closet I need to replace the rear door slides and can not find any to fit. There's a A stamped on it with Kennatrack. Can you tell me what size I need? Thank you!

Need to replace the four Kenna Track Closet Door Hangers on a 2 door built in linen closet in the master bathroom. The nylon wheel on the pictured hanger is very loose and will not stay on the track. Below are pictures showing the dimensions. It appears that the offset is 1/16". I look forward to ... (cont.)

I would like to buy the above A & B parts.

Dear Sir, Could you please suggest me what part number I should place for orders? I need 2 of them for now. Thank you, Seiji

I have an old Kenna sliding door system in an apartment. The wheel diameter I need is 3/4". Are the wheels on 23-051 and 23-048 this size?

3 inches high,1 1/4 in wide 1 1/16 offset doors are 1 3/8 I think it was an ACME because the only marking is on the backside and is a capital A inside a circle which I think may be trade mark for Acme.It has a cam device to adjust the height of the door from the floor.

We are trying to find a pair of replacements for the part shown. "Scottie Kennatrack" is imprinted on the side of the roller. The closet doors may be original to the house, which was built in the mid-1960s.