Viewing all customer Discussions for:

81-098 Pella Patio Glass Door Roller Assembly

Can anyone tell me how to remove these sliding door roller assemblies? Two rollers one left side and one on right side. There is a hole for adjustment on side of door but no other screws close to the adjustment hole. I expected to see tabs on bottom that I could pry up that are shown in almost all o ... (cont.)

The door is Pella, just the glass is guardian

Hello - attached are the four photos I took plus one I marked with dimensions (in red ink).Here are what I got for dimensions:2 3/4" Length of roller body1 5/8" Height of body5/8" width overall 1.5" Diameter of roller wheelHope you can read & see these OK.The sliding door is at least 22 years ol ... (cont.)

I need 2 new rollers for my Pella slidding door to the best of my knownlege( ability to read a tape) 1"3/4 High 2"3/4 length 3/4" width. I need to order this before shiping goes out On Wednesday. My husband cave manned it and now I have 2 old dogs who cant get to the ramp (Labs none the less) becaus ... (cont.)

Here are the photos of the door I need parts for. It is the roller and it measures 1 1/2" .

From a Pella wood door

The bearings are shot but the mechanism is good. Roller is 1.5" od

I have a designer series pella sliding door. I need to replace rollers. What roller would be right I haven't taken door off yet. Any good ideas for replacement the door was installed sept of 2001.ThanksDennis

Have 1986 Pella French slider door and trying find new rollers for them.

I want to be sure I am ordering the correct caster sets.BillThank You

From pella door, 1983. 7 cm x 4.3 x 1.7. Nothing printed on part.

I have a 4.5 year old Pella sliding door that is heave to slide. it is not binding or making any noise. I removed it and the dimensions are 2 3/4 by 1 7/8, the thickness is 5/8 with a 3/8 x 1 1/2 wheel. It also has a flange. You list 2 sets of Rollers a 81-098 and a 81-244. You have in the descript ... (cont.)

Do you have original Pella rollers to replace these? The Pella doors I have are from around 1981. Attached are photos. Regards. -Cliff

I'm looking for new replacement rollers for a Pella sliding glass door whose serial number is 16CFR 1201 II SGCC 1921 1/8U, with CTGB Tempered glass. It was installed in 2002. Do you have a roller that would fit this door?

Sliding double Pella Door, probably from 1990s

I have a 5' Pella sliding glass door that is used daily with the blinds between the glass that needs new rollers. I believe the door was installed between 1995 and 1998 - I think?? The door has just one hole on each side for roller height adjustment and it appears the roller assembly is 'pressed' i ... (cont.)

is the Pella 81-098 stainless?

Rollers for pella sliding patio doors pre 1998

Bearing is shot. Have not found a direct replacement with the flanges.

looks like etchings in glass pane read: CTG Tempered 16CFR 1201 IT SGCC- 1805 5/32 u