Viewing all customer Discussions for:

82-049 Andersen Thumb Latch, 3 Panel

Looking for a replacement of the latch assembly

Good Morning, I am looking for a replacement of the attached O ring door lock (just the plate and the middle part) not the lever. Thank you!

The photo is the lock in a what I believe to be an A/W 200 Series Perma-Shield gliding patio door. It was stuck in the locked position. When I disassembled it, I noticed the key cylinder doesn't have any type of 'blade' to turn the lock mechanism. So perhaps it broke off and jammed the lock mechanis ... (cont.)

Missing the mechanism (back of inside door pic) that rotates against the outside door (circular) latch. Looking for replacement parts.

Hello, I'd like to order this thumbturn or similar, same color.

The only hardware I think is salvageable is the thumb latch and the 2 handles. Photo #1 shows weatherstripping I took off the door. There is also a profile of #1. Picture #2 is a stifff plastic with a cut out for the lock. This piece attaches to the outside of the sliding door. There is also a ... (cont.)

Hi I need set of lock and handles and thumb latch. Can you pls provide the quote. Thank you and regards Zafar

Door is circa 1986

Need to replace the lock on my sliding door

Is the lock part we missing I've never seen that lock before so idk where to find it.

Looking for keepers

Could you please confirm that the lock bolt assembly PS 3 panel listed in your catalog #82-056 is a match for the attached pic? I believe my sliding door is Andersen from circa 1989Many thanks Patrick

Thumb latch broke off

Our home was built in 1992 and the exterior hardware of our gliding three- panel door is broken and I?m not sure what part or parts I would need to fix it. Here is a pic of the broken hardware.

I have Andersen, 82-048, 82-049 and 82-056. Do I need both 82-058 and 82-057 to make my door lock.

Please see enclosed pics of a broken exterior patio door handle. It doesn't seem to be an Anderson because of the extra vertical flat bar at the base. Can you recommend a replacement with screws? There are two markings on this handle. one marking has an "A" with a circle around it. The other marking ... (cont.)

Please take a look at these three pictures of my sliding door latch to help identify the parts that I need. Thanks, Mike

Hi there, Seems its time to replace the entire lock system on my old Anderson 3 pane sliding doors. Would you have these parts (pics attached) or something I can retrofit? Thank you very much. Best, Harvey

We have a Perma Shield door that is missing handles and the inside thumb latch (Product Code: 82-049) we are thinking that handles 88-013 and 88-014 would be appropriate BUT the sliding panel slides INSIDE the stationary door jamb and i'm wondering how the exterior handle will fit between the door s ... (cont.)

I need to replace two of our thumb latches. The "thumb" part is extremely loose on one door and loose and no longer latches on the other. The part # 82-049 looks identical but I am measuring 3 1/8" top to bottom and 2 1/2" screw to screw. (A little smaller than the shown measurement) I don't know wh ... (cont.)