Viewing all customer Discussions for:

23-177 Front Bypass Hanger, 1/16" offset

They are old closet door rollers from around 1954

Looking for a zero offset roller for my closet doors I ordered 23-177 as it is only 1/16" offset and thought it had the best shot at working I also see 23-015, but i'm not sure

Hello Swisco. Do you think item 23-178 and 23-177 would be appropriate replacements for the rollers in the attached photo? The measurments seem to be the same, however, i am not sure if the width of the wheel matches. Any guidance you can give me would be great. Thank you.

HI Swisco!I received an order a set of front and rear closet door roller hangers.I need the same offsets for both front and rear but need the smaller roller wheel (2mm) as these are for older doors and track.Picture attached.Can you help and thank yo in advance!John

Pocket door hangers the only identify mark is in IMG_402. JPEG It appears to say: SCME No 41 Pasadena IMG_2680 is the hanger.

I am inquiring about replacing this closet door hardware. The door is 1 1/8" thick and the back track offset hardware is 1 1/8". I was unable to find the proper wheels with the matching offset. The doors are from the 50's with I believe to be original hardware. I found a "no 3000" as the only discri ... (cont.)

Do you got these in 1-1/8 offset Thank you One is e-z roll Howe mfg inc The other is ?

These rollers have been in the house since 1956. Can't find these anywhere based on my photos do you have anything like this? The medal bracket is flat

Hello, Does the item Number: 23-178 (Rear Bypass Hanger 1-1/2") come in 1 inch? This is the size i'am looking for. The attached picture is the one I currently have. Thank you in advance.

Rollers are 1 1/4" dia. X 1/2" wide. Front bypass hanger has no offset, rear bypass hanger has a 1" offset.

Hello, I need to replace these old rollers with new ones. I seen some on your site that were very similar. But the bracket was a quarter of an inch wide. I don't think it'll make a difference but I am not sure

Cox and sons use to make it and it has bearings inside. I just need something similar.

Hi! I have a pocket door in need of repair. House was built in 1955 and I am looking for any replacement roller that will work on the track that is in the wall. Otherwise I will have to tear out the wall. So I have the door, and in the photo I have the bottom right piece as it is attached to the do ... (cont.)

cant seem to find these two rollers sizes

I have been looking for this part everywhere ... but can't find it

Looking for a 4 sets of these rollers. The large one has a 1"offset

Hi,Attached are photos of the front roller. I'm hoping to find replacement sets for both front and back doors. House was built in 1954 and these are the original closet door rollers. Any help would be appreciated."ACME No. 3000 Pasadena" inscribed on the back.Thanks,

We have a room in our 1940s home that has a closet running the width of the room, accessed by a pocket door on each end. The track is behind the wall, and because of the construction, we would have to remove trim on both front wall and inside closet, plus remove all the frame around the door in orde ... (cont.)

The house was built in the 1950's We have 4 sets of theses

I believe that the 2 parts on the left started out as the same part at one time. Please advise if you have these 2 or 3 parts. Thanks very much. Thank you