Viewing all customer Discussions for:

S351-34 34" Series 351 Channel Balance

34 inches window balance metal rod Jordan window 33-3

The metal part of the valence is 34 in Long I would need six of them complete and one retainer clip for the inside of the window track

Hello, I am looking for this window balance. I need 18 of them. These windows are no-tilt. The depth is 5/8". The width is 9/16". The length is 34". This house was built in 2006. Thank you in advance!

34" balances came off a 2006 Jordan window build home. Photo has stamped numbers 33 3 and BS l RM(see pic). Looking to order at least 8-12.. any help appreciated... thx Cj!

Looking for the replacement parts if you could help

My name is Bob. I need a replacement channel balance per the photos attached. The channel is 34" long without the channel guides.Thanks so much!

33 2 can Caldwell - stamp Label on theWindow - nami ANSI/ amazing 101-88 Code a-186-1 Spec dh-r30 Series 400 I will need 2 34" length of channel balance Along with the balance tops and shoes Thanks for your help Joanna

Can you help identify? Balance numbers 2920, 3340

I requested identification of this last week and have not received an answer. Don't know if I messed up sending or you are just busy. If it is a repeat I am sorry.The metal part of the balancer is 34" long.Thank You,Bob

The metal part is 34" long.

Just checking before I order this part. What I came up with was the S351-34 option 3340. The shoe is 1" long. The metal is 34" long. The window weighs 24 pounds. Thanks for your help!

What size would this be? Do you have them available?

I'm looking for a channel balance for windsor vinyl window.The Metal part is 34 inches longThanksJohn

Just moved into a new home and have several windows with bad balances. Would like to verify the correct replacement parts and order.

Hi, I need 4 lift assist spring assemblies. 33 B is stamped on the side. The metal is 1/2" wide by 34 long . Thank you, Mark

This is 34" metal length 1/2" wide "Caldwell 33 2 BN" (see picture) that is for a 34"w x 36"h window that is approx 20lbs. I am looking for the equivalent replacement part It's over 25 years old

I'll need 8 window balancers. The length is 35 " overall, the metal section without the plastic ends is 34" long. The width is 9/16" and the height is 5/8". Will also need 6 plastic stops that screw into the top of the sash, there are right and lefts. Will need 3 each. The square top is 7/8"×7/8". ... (cont.)

I am looking to match up a channel balance. The numbers on the unit I have are 3390 EF B.S.I. 33. the Channel measures 9/16" side by 34 long. It matches with Series 351 but I can not find a spring rated for 3390. Can you please advise on how to match this up.

I have a 3350de BSI. the length is 34" but i am having a hard time picking between the 390 and the 351 for my window. its a half inch width too. Anthoni

I'm trying to replace the channel balance on a ALENCO window. The channel balance is 1/2" by 34". But I don't know which ends to order with the channel balance. The existing channel balance has "33 3 EN CALDWELL" written on one end. Thanks, rob