Viewing all customer Discussions for:

81-246 Roller Assembly, 1-3/16" Steel BB

These are bottom installed an have a concave wheel about 2 inches in diameter looking to replace for my 12 heavy wood closet doors

I need 2 patio door rollers. Fixed wheel with the mounting holes about 3 inches apart

Need replacement rollers for sliding garage doors!

This track supports 3 aluminum frame polycarbonate sliders. Total Length is 91". Track width for each door is .750" Doors ride on Swisco 81-246 Roller Assemblies

This roller is off a 4 foot wide garage screen ( 1 of 4 screens). I need 2 per screen, need 8 total. Don't know the screen manufacturer. It's a crappy design where the wheel rolls in a track that traps water and dirt and gets all rusty.

I am looking for sliding glass door rollers. Sample photo enclosed.If you do not have, would you know where I might find them? Thanks,David

Hello, I'm restoring some old sliding glass doors that previously used wooden guides. I want to replace them with metal T-track and sheaves. Do you have the product submitted in the photo? (Grant #20 sheave) Or a suitable alternative. Thank you very much! Lynn

The first picture is the roller. The second piece is to hold support bar to frame. Help?!

These are old closet doors (1955?) The single wheel slider on the bottom has worn out or broken on several doors. The only marking on the roller is "Flushing, New York"

Looking for replacement aluminum sliding glass patio door bottom wheels. Picture posted

I need to find these door rollers for a glass patio sliding door

Please help me and get back to me.

These are from a screen door system that closes the length of a double car garage door. Four panels with two rollers in each door. Age of unit is appx 27 years old.

2 5/8"L X 1/2"W X 1 1/4H

I am looking for a part like this for a vintage cabinet door. The hole to hold the roller guide is 1 5/8" by 3/8"

I have a 1990 Silverton with a Taylor Made Sliding Door. I'm looking for replacement rollers. Mine look like your roller listed as product code 81-004. Can you confirm this is the right item? Are these all metal rollers.....stainless steel?

Hello, I'm trying to find a replacement for this roller, I think, it's from the late 80s or early 90s. Thank you!

Looking for these. The door was installed in 1945

Looking to purchase 4 rollers to fit in a mortised opening in my sliders. Photo attached.

Hi, Wheel is rubber and measures 1 3/16, assembly measures 1/2 " by 2 5/8". Stamped on the assembly is "F" in a circle and then the numbers 304. I have included two photos. Thank you! John