Viewing all customer Discussions for:

81-249 Glass Door Roller Assembly, Fits Pella

Roller for 8 foot Pella patio door built approximately in 1995.

The is a Pella slider door. I need new wheels. I have no reference to the type of door. Anyway you could tell?

Width 5/8", height 1 11/16", 1 1/2" diameter wheel, length 2 3/4"

I didnt' take pictures installed and now the door is back in place awaiting new parts. I hope the pictures are adequate to find the correct replacement.

The roller is broke as well as the lock

Length 2 3/4" width 11/16" height 2" wheel diameter 1 1/2" axle diameter 3/8" height adjustment screw at top of housing

These rollers are bad and need to be replaced, however I can't figure out how to remove them from the door to take measurements for replacements

I unfortunately don't have all the information you generally seek. But I have an older Pella doorwall. I was unable to find any numbers or markings. My rough meausrements of the roller indicates a length of approximately 2.75", a height of 1.75" and a width (excluding the flanges) of roughly 0.5 ... (cont.)

Hi , I have a 20 years old Pella sliding door that needs new rollers . model 7282 designer series. Thank you

Needs replacement

Single wheel roller, metal wheel . 2 3/4 wide 1 11/16 tall 11/16 deep Wheel is 1 1/2 x 3/8

No numbers on part. See pictures.

Hi, The bearing on my sliding door went bad, so I'm looking for a replacement. Outside housing is 3/4" wide and 2 3/4" long. Thanks, Andy

We recently purchased a Pella glass sliding door. After installation it was noticed the right side roller was missing. Where can we get a replacement roller. Serial number is V0401193666.

PS11 6L oper Pella slider door I need to replace 25 year old rollers . Very hard to open and close after using grafite with no success

Below are the Numbers I found on the door. ELLA -PEL- 1003 - ASCS FVF122- 071E080CWHT - 5263 -NFRC I hope this helps

1980's large (approximately 47 x 96) sliding glass door. I believe it is a Pella. Need help identifying. Please see photos. Thanks

Trying to replace rollers for pella sliding patio door! The number on the window is ICCC CBA IGMAC insulshield CIC-22-04 your assistance is greatly appreciated

There is no model number listed on the side above the handle, nor on the glass inside. I need to model number to get and price the wheel assembly.THank you,Marley