Viewing all customer Discussions for:

23-500 2 Door Sliding Closet Door Track Kit, 4ft

Do you have any closet door rollers with a half inch or 5/8" wheel? It is just a wood sliding door. The rollers are missing from one side and I haven't pulled it off the track to take out the other side (am trying to avoid that if possible). The rollers are convex. I could get by with a setup wit ... (cont.)

Looking for 4 of these...

Trying to find a match to my current sliding closet door roller assembly. It's top mounted. The roller wheel\bearing is worn out - and causes the door to slide loudly, and bumpy. Hoping you can look at the pictures I sent to let me know if it's available. Thanks!

23-056 roller I need roller track 4' or 6' long , how much with shipping to 48218

I need to replace the track and rollers on a freestanding wardrobe. The opening is 45 3/4" wide. The doors are 3/8" thick - and not close to 60 pounds. The 23-500 seems like it would work, but the track is slightly too long. Can the track be trimmed? If so, what do you recommend for trimming? ~ ... (cont.)

Grant Rocket 3/4 Front 1-3/8 Rear Grant Rocket 1-3/8 Front 3/4 Rear

Hello. Can you help me identify the proper track to purchase for these closet doors ?The opening is 48" . The original tracks were thrown out . These doors are in a mobile home (estimated built in the late 70's . ) Doors are in good shape as well as the hardware .

These are closet door hanger rollers marked with the letter A.

I have a set of old closet doors. The rollers were kind of worn out. I'd like to seek for replacements. I tried to measure and draw the dimensions. Hopefully those files make sense. Thanks a lot. Amy

Do you carry the top rail identified in the .jpg attached? The railing is from a mirrored closet door with the overall dimensions as follows: Front face 2 7/8" high (section that faces into room); 1" 'C' opening for slider rollers; 2" width between slider rollers. I do not have any names or m ... (cont.)

Local hardware store found this info Small model #6717. 5200274 Big ?? AFC is the only marking 1960 vintage Charles

My challenge is that the wheel is only 5/8" and the existing track will not accept anything larger. There is no off-set however a slight one could probably be tolerated if I purchased two for the same door.

Are thes track good for 1 in thick doors,wood. width 118 inches. Three panels. 2 in back,one in front . Existing track is ceiling only.very poor function. Need top and bottom track and hardwarw sincerely, Norma

Need to find part to fix closet. Wheel .75" wheel and mount to wheel about 1.375"

Hi I'm trying to build my own closet doors of wood. It'll be small roughly 20x60 each door. Most hardware I've seen mounts the doors on a top track screwed to the header. However I'm thinking I want to put these on a bottom roller track so weight is on the floor. Can you help assist me to find the r ... (cont.)

I have a Kenna door hanger similar to your 23-0051, but my hanger has a (3/4") diameter wheel. Do you have anything with a 1/8" offset and 3/4" wheel that might work? 7/8" diameter wheel will not work, I tried the 7/8 wheel size and it is too big. Trying to avoid replacing the track. ... (cont.)

I have been going crazy looking for a roller for my closet door... The little plastic wheel broke in half which renders the brackets useless... The problem is that the bracket is so old and I can't find anything that will work. You have what comes the closest to what I need however not ... (cont.)

Please take a look at the enclosed photos of the subject wheelset. The wheelset is original to the house, circa 1962. It is aluminum with the markings "To Lower Door" around the adjusting screw and and the words "Pat. Pend." above an "LB" insignia. The "LB" insignia is inside a square box and loc ... (cont.)

Hi, I'm changing my metal framed sliding bypass doors to a wooden bypass doors. I've identified my existing door hardware as top #23-196, and bottom #23-215. Can you please suggest the correct hardware for mounting to the rear of the doors? Door are 3/4" thick and I'd like to reuse the ex ... (cont.)

Looking for a replacement track for Bypass closet doors - closet opening in 46 inches?