Viewing all customer Discussions for:

58-171 .270 T-Slot Foam Filled Bulb Weatherseal,12ft

I have replacement windows with some worn out weather stripping. Attached is a picture. Thank you.

Good afternoon. I have a home built in 2001 with contractor grade double hung windows. I do not know the manufacturer. I need to replace window seals on the bottom of the window. Attached are photos of the existing seal. Note that the window seal appears to be a T-slot foam filled bulb weather ... (cont.)

I believe these windows were installed when the house was built in the late 1990's. Here is the information found on the window label. Quality control and testing AAMA Certification Program Accredited by American National Standards Institute A-L-I Validator Mfr Code STI-1 Series 1100 ANSI AAMA ... (cont.)

I am looking for weather stripping for a kvw window that was install around 2003. Please let me know what part you think will work. Thanks

Seal on bottom edge of lower Superseal vinyl double hung tilt . Sun has destroyed all the seals where the bottom sash rests on the window sill. Sill seal on Superseal double hung has deteriorated due to exposure to sun. This seal attaches to the bottom of the lower window sash and seals against the ... (cont.)

Will this weather seal .270 T-slot work on my windows? Looking at ordering 5 of them if this one will work or if not then what will?

I hope you can help me. This came off the bottom of my 23 yr old Simonton vinyl window. It slides on the very bottom of the window and when the window is down it keeps the rain, etc out. In picture#1, it is the outside part. It is suppose to have rubber on the piece on pic#2. I'm needing to replac ... (cont.)

I measure bulb at 3/8 wide. And side profile 3/8 using instructions from the video. But so dry rotted hard to tell

Looking for replacement weather stripping for a CertainTeed windows. have lower sash lift rail Part Number H6596MXX your parts numbers 58-171 and 58-182 look very close can you help me get the right one?

Hello! With the attached photos, I need help identify my window weather stripping in the picture, if you have it or do you offer something in its place? Channel = 3/16th" wide Brush = 3/8th" wide

Replacing all the window lower seals cannot find here they are fold inward lower windows seal snaps in grooves of frame with T shaped

I think this is what I need. Ours are so old and broke it is hard to see and measure. The one with the red ruler shows the entire width of the plastic and the other one is just the part that slides in the groove on the window.

This is for horizontal slider windows on the porch. 25 years old. Any thoughts?

The balances in my Simonton window are broken. I attached a picture of the window description from the original house plans, in case any of those numbers help find the right parts. The numbers on the coil we pulled out are worn. It looks like "5.0 35 08..2924". The track is about 9/16 inch deep. Do ... (cont.)

I'm looking to replace the broken seals and weatherstripping in many of my windows. I don't see a manufacturer on my sticker. Two sets of windows purchased at different times but same manufacturer.

Hello, can you please tell me if available what i halve circled around?

Gos on bottom of my double hung window

Suggestions?

Pictures show a side view of the weather stripping needed. Label on the windows included. need 6

Can't find any markings at all. I do know they are vinyl replacement windows that say Permanent Temp in a corner of the glass.Need the weather stripping.Thank you. Tracy