Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

Need help identifying the parts needed

I can't find what Milgard balancer will replace this. Are you able to help me identify a replacement that will work?

looking for this part, it is 27" long. Can you help me with this? Thank you

I have 3 broken balancers in 3 different windows and they are all the same as pictured. All the windows are 36", with 3 sets of double windows in a 6' opening and 2 single windows in a 3' opening. The sash widths are slightly different at 33-5/8 for the singles and 33-7/8 for the doubles if that af ... (cont.)

My local shop ordered them for me, label attached. I need more, now that I successfully replaced them in a pilot project. What is the correct part# to order? These are Milgard single-hung vinyl windows from the 1990s.

The balancer is from a Milgard single hung non-tilt window. It is 1/2" wide and the metal portion is 27" long. (Thank you)

please help me identify these parts.

which non tilt channel balance model do I need to replace this? 27 inch long 1/2 inch wide code 26 4 FX CMC 11

Looking for replacement for this channel balance / sash. This is for the right side. Left side seems fine - it goes up and down with the window.

Balancer with 2620 stamped on one side. 28" long total from tip to tip Plastic block that mounts to side of window in track that holds balancer in place along the side of the window. 2 3/16" long 1/2" (maybe 5/16" wide

Hello,Looking for the part number for a Milgard window balance from 2003-2004.Please see attached photos.The bar appears to be 27 inches.Thank you,Rod

window weighs approx 16 lbs.The wings are just shy of 1in.the inside track width where spring resides is 9/16.from your site it look like s385.the metal length is 27 in.please help windows presently has no tracks as they were damaged as you can see from picture.thanksjay

27"long 1/2" wide Stamp is 26C USB I need 2 units. I am not sure is the mfg. no stickers on the windows. The house was built 20 years ago.

I didn't find any names, but the image with numbers hopefully provide what is needed. The last ones I purchased from you were perfect. These channels measured 28" long. I also need two replacement locks. I think you carry these too?Your help in so appreciated! ??Bonnie

We have two windows that need new channel balances and side release clips for two of our windows. We have contacted a local window person that was going to come out 3 days ago and left messages but no one has called us back or shown up. Can you tell us where we can get these channel balances local ... (cont.)

The channels 27 in Long both ends are winged everything else is in the pictures one side of the channel is half inch and the other side it's open because it's got little tiny lips on them they're 9/16 so I don't know what side you would measure for that thank you

need help identifying this balance

purchased balances from your company that did not work out I may need customs

Hi, As attached in the screenshot, the channel balancer reads "26 5 JW CMC 7". Could you please help me identify the replacement part? Thank you.

Need replacement channel balance. Not sure which one to order. Can you help. Hope pics help. Thanks. Kate