Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Plastic mounts for rails of cabinet drawer

I have this rear mounting bracket in my kitchen cabinets, and they appear to be missing all the screws to keep the sliding supports connected to the drawer. I'm not sure if the screws are actually needed. I am on a quest to find this plastic rear mounting bracket and read its installation instructi ... (cont.)

Hello, I'm in a months long process to replace a failed unigrass 22.5" drawer slide set on one drawer. Cabinet depth is either 22 3/4" or 23 1/2" (see photo). Drawer box is 22" to the back of the faceplate.The challenge has been to find replacement slides that can mount to the drawer box properly. ... (cont.)

I purchased a set of 32-018 brackets to replace broken ones. The broken bracket I have is stamped with the "G 6600", yet the new replacement bracket doesn't fit - it's too small. Are there other brackets for this series?

Rear bracket slide brace? 3 inch x2.5 inch. slide opening is 1 inch.

Need replacement part both sides of drawer plastic part broke

Hi! I am looking to replace the rear mounting brackets (left and right) for my old Merillat cabinets (installed in the 90's) The part was discountinued by Merillat in the early 2000's and I purchased everything that they had left, but I'm now out. I looked at another message from a customer who a ... (cont.)

Looking for multiple replacements of these items. Both left and right side.

Do you have a pair of brackets to replace these broken brackets? It is the back support for a drawer

Right side. Rear mounting plate/bracket for sliding cabinet drawer

My cabinets are from Haas. I need replacement part for part number 4930739. I need enough for 2 drawers.Marcia

Can I purchase this part?

Trying to get the plastic bracket that holders the slider in placeIt measures 2.5 in length from back to front

Hi. I'm looking for rear track plate on Scheirich drawer.

Looking for part I. Back draw

I'm looking for cabinet drawer stop. Width Inside 6/8 inch. This is where bracket slides into stop. 1 7/16 inch deep inside. Back side for cabinet mount inside 5 to 6/8 inches x and 1 7/8 long . Do you have something that will work? Thank You!

I just need to replace the left side

I am unable to find this black sliding drawer rear bracket anywhere. Please suggest thanks

Is a something like this available?

Do you have a replacement part for a HAAS kitchen cabinet guide stop for a drawer? This is beige in color. House was built in 1992 . Thank you. Patent number is 4930739.