Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Please help me find a replacement for this drawer track back plate? Length overall: 3 7/8"Height (inside) 7/8 - 1"Base: 1 3/4" x 1 1/8" Supports cabinet bracket marked 'A550' Thank you!

No markings on part

Do you have this

11 3/4" long

Having trouble finding replacement part for this late 90's builder grade kitchen drawer. Bent slightly from wear.

Inside of socket has number 3808. Interior height is 15/16", interior width is 3/8", interior length is 1.5" and there is a lip on one side. Socket appears to have slight curve, as do the slides. Slides do not extend fully into socket.

Pics are of drawer rail rear mount. Drawers installed 1995. It can be used both left and right with one screw attached plastic fits over wood rail. Too replace all I would need 28 pieces. Greg

Need help replacing this broken rear drawer track socket and no idea how to match it. Pictured here is the left intact one. Thanks.

message

Exterior of each leg is 2 to 2 1/4" long, where the slotted leg screws into the rear wood support. The inside dimensions are 0.9" or 15/16" for both the leg that attaches to the rear wood strip supporting the bracket, and the slot where the metal drawer track slides into for support. Nothing seems ... (cont.)

Hello there, I have a face-frame cabinet with wide drawer with side bottom mount sliders and back mounting bracket brackets. Drawer old slider is 23 5/8" side. The right side of the current bracket broke and the nylon roller of the slider also broke. I have attached photos for the old bracket that ... (cont.)

I purchased item # 32-061 but I did not relize that the slides are connected to the back of the drawer like in the attached pictures. I cannot find the correct set to purchase and I cannot figure out how to disconnect the ones in my home. Any help is greatly appreciated!

No markings found.

First Pic is the right side broken part, and second pic is the left side intact bracket.

I need to replace at least four drawer backplates Bottom - 2-1/2" Width - 1-1/4" Rail - 1-1/8" Height - 2-1/2" Thank you!

Need a kitchen drawer rear mount bracket. Has two pins on back of bracket, on broke off

It says Unigrass 6600 on the side of the drawer slide. The back wall support bracket broke. I didn't take a picture of it out because I'm having trouble getting it out.

I have a Unigrass 6600 drawer slide that I need to replace. It is. 21 5/8" long. I am having a hard time finding where to purchase one. Any information is appreciated!

This part goes at the end of the glide. It has a 1” opening to fit the rail end and a 2” length. Hope you can find It.

The left rear bracket that holds the drawer side rail broke. What is the replacement part? Photo 4188 is the broken bracket (part of it cracked off), photo 4187 is the intack assembly for the right side, photo 4203 is the front end of the side rail, photo 4204 is the back end of the side rail that ... (cont.)