Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

Do you carry this.

The two pictures show the broken right rear bracket from the side and head-on. It's not been easy to remove completely, so I didn't do so for the sake of this post. Big box stores have brackets that fit the drawer slide, however, they're too deep. The bracket I need is 1-7/8" deep. I believe this ... (cont.)

Can you tell by these photos which slides I need

I'm looking for a replacement part for what I believe are Rutledge cabinets. This the rear mount for the back of the cabinet. The picture is of the left side railed mounted. The right side is what I'm looking for. The only identification I can find in on the drawer itself.

Please help me find a replacement for this drawer track back plate? Length overall: 3 7/8"Height (inside) 7/8 - 1"Base: 1 3/4" x 1 1/8" Supports cabinet bracket marked 'A550' Thank you!

No markings on part

Do you have this

11 3/4" long

Having trouble finding replacement part for this late 90's builder grade kitchen drawer. Bent slightly from wear.

Inside of socket has number 3808. Interior height is 15/16", interior width is 3/8", interior length is 1.5" and there is a lip on one side. Socket appears to have slight curve, as do the slides. Slides do not extend fully into socket.

Pics are of drawer rail rear mount. Drawers installed 1995. It can be used both left and right with one screw attached plastic fits over wood rail. Too replace all I would need 28 pieces. Greg

Need help replacing this broken rear drawer track socket and no idea how to match it. Pictured here is the left intact one. Thanks.

message

Exterior of each leg is 2 to 2 1/4" long, where the slotted leg screws into the rear wood support. The inside dimensions are 0.9" or 15/16" for both the leg that attaches to the rear wood strip supporting the bracket, and the slot where the metal drawer track slides into for support. Nothing seems ... (cont.)

Hello there, I have a face-frame cabinet with wide drawer with side bottom mount sliders and back mounting bracket brackets. Drawer old slider is 23 5/8" side. The right side of the current bracket broke and the nylon roller of the slider also broke. I have attached photos for the old bracket that ... (cont.)

I purchased item # 32-061 but I did not relize that the slides are connected to the back of the drawer like in the attached pictures. I cannot find the correct set to purchase and I cannot figure out how to disconnect the ones in my home. Any help is greatly appreciated!

No markings found.

First Pic is the right side broken part, and second pic is the left side intact bracket.

I need to replace at least four drawer backplates Bottom - 2-1/2" Width - 1-1/4" Rail - 1-1/8" Height - 2-1/2" Thank you!

Need a kitchen drawer rear mount bracket. Has two pins on back of bracket, on broke off