Viewing all customer Discussions for:

32-334 1-1/4" Drawer Slide Spacer

Cabinet bracket is held by a small plastic part as seen in the picture. I am not able to find a replacement. Cabinet maker has been outbid business for many years. Local stores do not carry this part. No numbers on part.

I need a drawer slide spacer bracket that works with the closet maid impressions drawers.

Enclosed are pictures of a good bracket which is a side mount support for a kitchen cabinet drawer. Hopefully you have it and I can purchase 3 of them for broken replacements. Bob

We'relooking for drawer slide spacers. We have 8 that have either broken or are severely cracked. These are for Brookhaven cabinets installed, we think, in 2009.

Do you have this part

This block attaches the front end of a euro-style drawer slide to the front of a face-frame cabinet. It has no numbers, names or markings. It is about 1.3 inches thick at the deepest point. The back of the block atteches to the side of the cabinet and the front edge (where the slide attaches) is flu ... (cont.)

I am looking for kitchen drawer guides

I have the drawer slide spacer similar to your 32-339 but mine is 1 1/8" including base. Can you help? Thanks, Tom

This is the front left support bracket for a Kraftmaid Roll Out Tray. The tray is 31" wide and 24" deep. Kraftmaid's website does not show this particular support bracket. The one that is shown on the website is not the same shape. The photo showing the removed bracket shows 2 separate pieces. That ... (cont.)

Need to locate 4 drawer slide rear support and mount brackets. Willing to buy the complete drawer slide kit if necessary. These came on America Woodmark Corp. kitchen cabinets in the year 1990 purchased fro 84 Lumber in Jacksonvillle Fl. Cabinet part number is ROB30 Pull out base. Thanks for any as ... (cont.)

Hello,I have Brookhaven cabinets and as shown in the pictures above, the part that holds the sliding "rail" up, has snapped and now the drawer cannot be pulled out. The drawer otherwise is fine, but I need to replace the part that is screwed into the wall of the cabinet and holds up the sliding rail ... (cont.)

The piece I'm holding in the photo is broken. It is in my pantry cabinet drawer that slides out.

Front bracket is for right side of knife drawer that has no right panel or wall as the drawer is over a large cupboard below. The screw goes in the back of the front wood frame of the drawer on the right. These are Kraftsman cabinets

Do you have anything to replace the bracket below? I don't care if it is attached to a guide rail (sorry, I don't know the correct term). The rail is 19 7/8" or so long (20"?). Please let me know. Anna Bronnenkant'

I want to be sure I have selected the correct part to replace the spacer - I placed one in my cart but look forward to your opinion based on the attached photos/

Its plastic and you screw the long arm piece into it but unfortunately its cracked.

This is a hinge spacer that has 5 holes to mount it to the cabinet & 2 holes to mount the hinge to. Would you carry any of these?

Looks like a spacer that keeps the tray guides away from the sides of the cabinet.

My wife put a little too much weight on the shelf on the front left mounting bracket broke. It appears only the plastic part is broken so only that needs replaced. Neither the cabinet wall nor the long metal part appear damaged. I have attached a picture of where it mounts to the inside wall of the ... (cont.)