Viewing all customer Discussions for:

32-334 1-1/4" Drawer Slide Spacer

I need to replace the below part, which was installed on my KraftMaid drawers.

Need new part

We have a pantry with pull out trays, Ktaft Maid and the right front side bracket broke under the weight of the items in the tray.

Hello, I have Brookhaven cabinets and there's a crack in one of the brackets. I can't tell if the measurement is from the edge of the plastic piece or just the part that sticks out. What size do I need to get? Thank you

Hello, The attached photo is for a KraftMaid pullout tray tract supporter. It is on the top right side. Do they make this anymore and if not what could l use as a replacement? Thank you

I am looking for replacements for broken cabinet pull out hardware from 90's Woodmode frameless cabinet. The plastic strip is 22.5 "L x 3/4W x 1/4 D. The holes are 1.5 " apart. The part that supports the pull out is 2" L x 3/4 Wx 1 1/2 D (or projection). Any help would be greatly appreciated. Than ... (cont.)

Looking for ordering info for the parts in photo. Long upright bracket is 5/16" thick, and t-bracket extends 1 1/8". Thanks

Looking to replace broken plastic adapter for sliding shelf. 3 inches long; 1.25 inch between metal bracket holes; 1 6/15 inch from wall to bracket. What else do you need to know? Thank you for looking.

I am in need of 2 drawer track brackets. As you can see on attached photo I have 2 broken brackets. This is for a 2 yr old bathroom vanity.Bracket is approx 1.75in wide by 1.75in deep if that helps.Thanks,Dave

Do you have something similar to this part?

Hello, I am swapping drawers from one cabinet to another using the existing hardware including these brackets, pictured, and 21 5/8" slides. The slides are mounted to the cabinet using these two brackets on each side (one in front and one in the back). Using these brackets, the width is about a 1/4" ... (cont.)

Hi there! We broke our spacer for our drawer in the pantry. We ordered the 1" spacer but we really needed 1 1/4" I think. These are Brookhaven cabinets. Hopefully you can help us! Thank you! Milena

I ordered a 32-339 thinking I could use a spacer, but the screw holes don't match. Is there a better match?

Need a replacement for this piece, having trouble identifying it. Thanks!

I have Brookhaven kitchen cabinets and one of the slide spacers is broken. What is the correct part number for it. To help me assist, I am attaching a photo of the same. The corresponding measurements on the slider in our Cabinet drawer are 1" 2/16 in depth and 1'.5 distance between two screws spac ... (cont.)

Not sure what to call this -- it mounts a drawer slide at the front to the side of the cabinet -- the post projecting out fits into one of two holes in this (Kraftmaid) cabinet from a circa 1999 or 2009 remodel (before we bought the home). The slide is suspended about 1/2" from the cabinet wall. Th ... (cont.)

Hope you can help, we need both lengths drawer glides 17-3/4 & 20-3/4. 4 sets of each. also need 8- 1" plastic spacers to hold glides at correct width

I need 1 pc of the item shown.

I am looking for drawer slide spacers that are 2 inches long. The ones I have seen advertised are only 1 3/4 long so the holes don't match up to the pilasters that are attached to the cabinet and they need to be 1 3/16 high. The ones that were originally installed are cracking and breaking. ... (cont.)

Looking for attached part