Viewing all customer Discussions for:

84-139 Norco Screen Door Roller Assembly

I need the white plastic housing and wheel basically everything for two wheels and will order an extra likely.

Do you have a replacement roller assy. For Jeld Wen patio screen door. Roller is 1" dia. X 1/4" wide, steel wheel. Would prefer plastic wheel.

Is there any roller assembly part that can be subbed for the Norco 84-139?

The bottom rollers (pic attached) is broken. I believe the replacement part is 84-139, but not sure. I had a hard time taking it out..it broke into pieces. Will there be instructions to remove and install included if I purchase a new one? Thanks,

My question; These rollers are poorly made and I expect the new rollers to fail in a few years. Do you have something I could retrofit that will last longer? Also, these rollers are on the top and bottom of my door. I suspect I only need one set on the bottom and not the top. If this is the cas ... (cont.)

I believe part #84-139 is the correct roller for my Norco sliding screen door. Can you send me an instruction sheet so I can remove it to confirm.

Attached is a pic of the screen door roller that needs replaced. Can you help me? Thanks. Keith

I need to replace this wheel that came out of a Jeld Wen screen door. I bought the door in 2006. I believe that the part number for the door is JERL01790 Do you guys sell this?

I've attached a picture of the screen door roller assembly that I'm looking. The housing is plastic with a leveling adjustment screw located on the side. The wheel material is steel and spring loaded. The installation to the door is snap-in and requires no tools. I recall purchasing the sliding d ... (cont.)