Viewing all customer Discussions for:

10-057 Ball Catch with Strike

For the closet door to be close

I need to order a replacement

Can you assist with a replacement pair of ball catches with these measurements? I bought a set from Amazon that indicated the length was 1 1/8 inch but it ends up it is slightly too short.

I need to replace the same type of male THREADED ball catch and spring on my closet door. The male part (pictured) screws into the brass female catch inside the top of the closet door. The treading allows the ball to be adjusted so the closet door closes securely. I'm not sure the one you recommende ... (cont.)

Cylinder fits in slot on top of closet door. Should have a rounded piece in top to lock door in place once it is closed

See the attached. My brass ball catch can no longer hold the ball in place. It looks to be identical to your product 10-057. I believe that the screw-in piece is threaded at 3/4"-16. Can you confirm that this is yours? Thank you, William

Size 1 1/4" Height Bottom width 3/4"

1" x 2 1/8" metal and brass

This ball catch is for our closet door. the diameter is 13/16 and the length is 1 1/16 under the rim. thanks james

Looking for the above parts

I am trying to find the replacement part for this door catch. It is for a pair a French Doors and holds them closed. It is on the top of the door. And presses into the door jam. I will take pictures of the broken one, the one in good repair and the door jamb. Thank tou, Brett

Please help in determining part # for replacement fit. Thank You ?

You can see the size of the bulk I need on my diagram. The important thing to know is I need smooth sides, not with a notches on it. This measurement has to be 13/16 of an inch..

Does the center part with the ball screw out. My ball catch ball has popped out and won't stay in. The part that holds the ball screws out of a liner that has been sunken into the top of the door. I need the replacement that screws back into the liner. Of course I am glad to buy the unit. The su ... (cont.)

Hello this is for a closet door . It is located on the top of the frame. Do you have a replacement? Thank you.

I could use your help in identifying the item (I know it's in parts) below, and (hopefully) a replacement, or, if not, a workable alternative. This item comes from one of our closet doors, and is seated in the upper left-hand corner of the door. As you will note in the attached photo, the upper por ... (cont.)

this presses into a brass sleeve which is pressed into the top of a fairly heavy door 7/8" diameter, 1+1/8" length cylinder 1" diameter rim

Do you have a replacement? ball for top of closet door that when closed the ball holds door in place I am trying to replace this seal on jeld wen vinyl windows. Please tell me you have this product?

Good morning. I have a few closet doors that all have this ball bearing type roller that rolls into an attachment in the frame that keeps the doors closed. One of the rollers is missing. Do you happen to know what part this is? Thanks! Craig

Looking to see if you were able to help find the item attached or where to find the marble that goes on top? This item are for closet door, like latchers. Meanly to keep the doors closed. They go on top corner of the doors