Viewing all customer Discussions for:

10-057 Ball Catch with Strike

This flush mounted plastic latch is broken - I need a replacement. I'm not sure exactly how this broken part is removed and the new part installed but I'll figure that out after I determine if a replacement part is available. THANKS Dan

The latch is means to hold the door in place when it's closed, but not locked.

I am wondering if Part 10-057 is what I need to replace a damaged ball latch. There are three pieces to my item: (1) a cylinder that is 1-1/8" high with a 5/8" diameter opening at one end, (2) a threaded insert that is about 3/8" high and screws into the cylinder, and (3) a metal ball that fits ins ... (cont.)

Recently, the metal ball popped out of this part. It is used to secure the closet door when closed. Is there a possible replacement part for this?

Hi I'm in need of a few St Charles Ball Latches. Would you have some?The part snaps in place, but is plastic so it broke when i tried to remove.Rich

Had a ball in the opening. Hold door closed. Ball is missing now.

Hello,Can you supply me 6 of these?Thank youTony

I think I have your Ball catch, product code 10-057, and I want to adjust the height of the ball (lower the ball, to make it easier to open and close the door). I see the two notches, separated by 180 degrees, on either side of the casing which surrounds the ball. I presume that is where the tool is ... (cont.)

Need to replace this hardware - Retractable ball broke loose from the restraining sleeve (Sleeve rim broke off due to use) Need to locate replacement parts The sleeve looks to be 13/16 in diameter.

diameter 11/16 of an inch height 8/16 of an inch

I see several discussions regarding the same ball catch I have, but don't understand the configuration of the replacement unit suggested. (10-057) Attached are pics of 1:the female housing buried in the top of the closet door and 2: the male portion containing the spring, minus the ball. The male p ... (cont.)

Spring loaded lock

Can you please tell me the name of these parts? I would like to order. The ball bearing keeps popping out. Spring is too strong and top is worn and won't keep ball in. Thank you

I'm just trying to find a solution to fix problem or replace if necessary.

It looks like they are about a 1" roller with a bearing and shaft. I have two that have been turned into cams instead of wheels! I'm also looking to replace the nylon latch insert that keeps the cabinet closed. I have resorted to using magnets, but if you have the nylon latch, I would totally repl ... (cont.)

The ball is missing but I was able to remove the part containing the spring. I cannot find the size of the one installed and since the hole is bored into the door I need to find one the exact size. There is no manufacturer listed I can find. I recently bought the house which is 2 years old. The casi ... (cont.)

If you unscrew the insert inside with the ball and spring, what?s the diameter over the threads and what pitch is the insert? And also what?s the diameter of the ball? Thanks Pete

This piece fits at the top of the closet door and connects with a metal piece in the door jamb. There was a metal ball in the piece in the photo but is missing. Help! Thank you

I ordered part 10-057 and it is too big.

This came out of the top of my bi-fold closet door. It should have a metal ball bearing in it that when you close the door, the bearing catches on a metal plate mounted on the top door jam. It is 3/4" in diameter. It threads back down into the top of the door. The bearing apparently came out and ... (cont.)