Viewing all customer Discussions for:

33-087 8-32 x 3/8" Phillips Truss MS Zinc

Hi, I could also use some help on how to attach sliders on bottom of glass doors. I totally forgot because it's been a few years since i have had the doors off. I do have the rollers on the top of the doors, so i guess i'm set to go there. Just not sure how the bottom sliders go. If there are on lin ... (cont.)

The hardware on our kitchen drawers is Grant 338. They were installed in 1985. The front roller on the drawer guide has broken. Are the parts still available, or is there a replacement that you could recommend?

right drawer rail Grant CR 348 22" long /roller disk is broken but is 7/8" ,the rail is 1 inch wide with interior 3/4 to 7/8 were roller fits in to.roller

I have nothing to identify the door. It's anodizing 40+ years old .

I need to replace drawer roller or ring for a steel drawer. The drawer faceplate is 30" wide and 6" high. The roller is a hair over 1" (28mm) outer diameter and exactly 1/4 inch deep. Photo a: Damaged nylon roller Photo b: Roller wheel without ring Photo c: Remaining roller

This is a built in file cabinet in our house and the wheels for the slider have disintegrated. They look to be 7/8" wheels made of nylon. Looking for a replacement wheel or the whole slide unit itself. The slide is 13 1/2 on file cabinet. Any help would be appreciated. Thanks! Dylan ... (cont.)

Hello I am looking for replacement Rollers for the Drawers in my Steel Office Desk. They are actually a Plastic or Nylon Roller bearing that is riveted into the drawer into a hole on the rear sides of the drawer on both the left and right side. They fall out after time from the holes they are rivete ... (cont.)

Need replacement roller for kitchen cabinet. 1/2 inch diameter. Thank you, Robin

Hi, I am looking for a Drawer Roller, it has a nylon 5/8'' roller wheel, it is flat on rolling surface, w/little bearings. thanks, Joe

US Patent # 3980364 15000AB-3 (not sure what this number is) The wheel broke in half on the right side plate. Please help!! Thank Katherine

Older mirror door for a closet. Need a top not an off set roller mount.

Where to by hardware to replace metal piece and rollers fior sliding glass shower doors..the screw is a flathead . Top part of metal cracked, that the roller ( Philliphead screw for rollers) is attached to

I had this desk powder coated and I did not remove the roller wheels for the drawers. They were 1 in D and 1/4 in thick with about a 3/8 bore I think. Do you have anything that work as a replacement? Thanks Ben

Do I have to dismantle the sliding door or can I take the top frame off the sliding door?

Shower door roller

I am looking for P.E Del Mar Roller, Part # 3522 Model SRO-89-HEX. Any chance you have it so that I can order a few?

I need two hangers like this with a distance of 1 1/4 inches. The wheels are just 3/4 inch each.

As pics show, says LAWRENCE on back. Wheel diam. is 3/4" My husband is the 'handy man'/contractor. Can't find anything local that will work. Thanks!

Goes on top of mirrored closet door. May be the original equiptment for home built in 1960. Thanks for you help.

Looking for half inch flat rollers for my drawers. .thank you