Viewing all customer Discussions for:

32-125 Drawer Stop

The pictures were of drawer stops that were at the top back of the drawers and were stapled into a cut-out in the back of the drawer. When I removed the drawers to move the dresser several of them broke.

I need 6 for my bedroom drawer chest

I need eight of these. I try other kinds but it has to be the combo stopper glider for the drawer to work probably.

Hello, I have an old roll-up desk with a plastic security tab found in the back of the center drawer. The tab was manufactured by Ronthor in NYC and the serial number is R-51-424. It wears and tears quick, so I'd like to get some spares. Do you have anything similar in your inventory? If not is ... (cont.)

Drawers pull out and will not stop. Plastic part on back of drawer does not look broken. What is the part I need to stop the drawer from pulling out for wood center drawer glide. Thank you

Rubber piece to keep drawer closed on chest of drawers

Hello!We have acquired a 1976 Thomasville dresser. All the drawers fall out when you open them. With difficulty we get the a drawer to get into the rail ? then it doesn't close all the way. Do we need to replace all of them or are we doing something wrong?Thank you!Lori

I need to replace one of my Thomasville center Mount drawer glides from a circa 1980s chest of drawers. I've been reading your posts that recommend the 32-053 as a suitable replacement. Does the 32-053 have a system in place to not allow the drawer to just pull out during normal use? ... (cont.)

I had previously ordered part #32-078 for the front of the kitchen drawer, now I believe I need the back stop because the drawer pulls all the way out,Thank you.

This stop is under the drawer on a wooden glide dresser. Any help is appreciated

Bassett dresser drawer about 25 years old

keeps drawer from coming all the way out

Need a part which will keep dresser drawers from "falling" down when they are pulled out. Thank you!

Twist lock attachment that a drawer bumper hits to keep drawer from sliding out

Hi,I purchased some Thomasville furniture, Queen Anne style, between 1993-2001, and recently have discovered some of the drawer stoppers are broken. Note, I will be also purchasing some guides (corner, flats, etc. too).I've attached some photos, and I know I can manufacture a different DIY method to ... (cont.)

My Ronthor-NYC door glide broke when my daughter tried to get something out of the "hidden" middle part of my desk. (Sorry don't know what you call it) Anyway I tried glueing it but obviously that did not work. It is 1in in width snd 2in in length. Lite brown and has two screws. Where can I find a ... (cont.)

What's the thickness of the plastic please? Thank you.

They are all broken I can not find them

Need spring-loaded rear drawer bounce stops for handleless drawers.