Viewing all customer Discussions for:

26-394 Tilt Latch Assembly Pair

Need replacement lock for a vinyl window.

DH-R40 Series 1000 MST 4664Need help identifying this part to get a replacement

Good afternoon, I was wondering if you had a latch similar to the one in the picture. The holes are about 1 1/8 inch apart.

I can't find this combo part anywhere

I'm looking to replace 2 left side latches. Can you assist?

No label markings found on any window. Build date 2005 2006. Thank you

Hello, unfortunately I cannot find any stickers on any of the windows in this property. I need 10 of these tilt locks replaced. Do you have any replacements that will fit this application? Thanks Brian

Searching for HWLT 154I would like to find this part.

latch holes are 1.1". IT has a metal piece on the back that sides and locks the window in place with a cap. Of course it has the level that release the window for cleaning. There are two latches per window. I have 16 windows I need parts for. Most of my windows the metal lock has fallen off they ... (cont.)

Tilt latch for Flesher Windows located on left and right

Hello I am looking for 4 of these All the windows in the house have these that help you tilt the window. It will be easier to call me but if you cannot , you can email me . Thanks

Sliding window latch needs replacing

The windows tilt in for cleaning. They are single hung, slide up windows. I simply need to replace the latches in order for the windows to open. Thank You

Do you all carry such a latch/lock or can you direct me to someone who does. Thanks.

Where can I find this hardware? I contacted the company that manufactured the windows and they said they sell their windows to Lowes and try there. Lowe's does not carry this type of hardware. I believe they were installed when the house was built in 1990. There are no numbers or markings on the har ... (cont.)

I have it on the other window. It is broken and I will need both sets.

Hole center is 1-1/8" Length=2-3/8" Width=13/16" Thickness=3/8"

Need replacement latches for tilt Windows. Latch block is 2 and 3/8 inches long and screw holes are 1 and 3/16 inches apart. Original manufactuer was flesher windows in fort Myers Florida.

Our corner tilt window latches are breaking due to age ( about 12 years old ). I can't identify any numbers on them. Please help. Thanks, John

The first screw hole is 5/8 from the end and the holes are 1 1/4 apart.