Viewing all customer Discussions for:

39-539 Anderson Vent Hinge Pair

I received the 14 pairs of 39-539 I ordered and now realize the installation is a bit more complicated than I expected as they appear to be riveted to the aluminum bar that slides up and down in the window frame. In lieu of the rivet, can I use your 5/16" shouldered bolt if I tap (1/4-20) the slid ... (cont.)

I need hardware replacement for my awning window. Please help me find correct parts.

I need several left and right to renovate several windows

Pix 1+2 show broken off sissor hinge openers on North unit installed late 1970's 3rd pix shows intact unit which has scissor hinges as photoed on both sides of over n under glazings

This is a plastic piece in an older awning window probably from the late 70's early 80's. When the window is retracted, it helps keep the window tight to the frame. This one is in tact but I have others that are broken. If there is a difference, I need right and left sides of this part. ... (cont.)

?

Small plastic part on inside frame of crank window to guide hinge. Either black or white plastic. Window is at least 30 years old.

Looking for replacement parts for awning window. Found on your site but lost link. Curious on how to replace if item is replacement since all I've seen is riveted

I'm assuming that 39-537 is what I need? Looking at other picts. So excited if that is the case. Prob will need quite a few. Is there a volume disc!? I'll need 44 of those so far. Here are some picts. Thank you Anne

These plastic parts hold the window closed

I am trying to identify and find replacements for this Plastic pivot/locking hinge for older "awning" windows.

"PAT. NO. 3444648"

We are trying to find a part for this a 3 tier and each tier is 4 ft wide and fiftteen inches tall. One of these pieces broke and trying to find a replacement piece to fix it. I sure hope you can help. The patten number is 3444648.

I bought 2 pair of these hinges to repair a window and started tonight and then postponed until extended daylight. It appears that I have to remove both sashes first, as the uppermost portion of the hinge appears to be blind fastened to a nylon guide that interlocks with a continuous bar on each si ... (cont.)

I have a few of these broken and need replaced. Can you identify?

Hello, This picture is from crank out windows on a sun room. I don't know the manufacturer. Thank you for any help you can give me.

Do you have these parts?

Hi The plastic part that is hanging in brwindow2.jpg is what is broken and needs to be replaced. The brwindow3 shows how it is suppose to look like. thanks

I am hoping to restore some windows. I know little about window repair, to state the obvious, so I am hoping for your help. See attached photos 6 photos. 3 of which general photos which may help you identify the window. I will need operators (See photo) I will need bushings (slide bar guides) and ... (cont.)

Looking for part to double awning window, most recent one was black, original ones off white