Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

Winguard 954717-00-002 patio door. Dimensions: Base width: 5/32 Height: 3/16 Base extension: 1/16

The attached photos are of a sliding patio door seal, for the track on the bottom of the door. I cannot find any marking for manufacture of the door. It is a 2 piece setup, the rubber seal and the top slide that holds it in place.

This is trim from the outer side of the casement window of a certainteed window that cracked off and needs to be replaced.

1/4" x 1/4" foam sq with white plastic film(?)covering. The wood slot is 1/4" wide to accept with foam piece. The slot is 33 7/8" wide (actual tape measure of bottom of wood frame). The foam piece is also lightly glued in the slot. I need to replace the weatherstripping in 5 identical windows. In t ... (cont.)

Hello, I have a weatherstripping seal for the bottom of the window. The backer of the seal width is about .4-.42”, the channel in the window it rides in is about .372" and .320" deep. It is a simple shape, but I can't find a similar type. Thanks

Window seal that slides into bottom of window. I also have a bathroom window that have moisture build up on the inside glass.

I am looking to replace all of the weather seal. Do you have this type? See photos . The bubble measures 1/2". tyvm! Ali

need about 80 lf

Hi - the door has two sets of the same weather stripping. Flat bottom 5/16" wide x a strong 1/32" thick, bubble about 5/16" diameter. Thanks, Steve

Trying to identify the weatherstripping part. bottom t bulb is 1/8th inch diameter of bulb is about 1/4th inch bulb to the t shaped bottom is 1/8th inch

I am looking for simonton casement window weather seal, I will include pics of the old seal and the window information

It's old. The base could be 3/16 wide and the bubble could be 5/16 in diameter.

T slot fin seal for aluminum window

Norco casement windows mfg 1985 sizw is abt 1/4" dia. To 3/16" t slot offset with a bar

I would like to replace the bottom weather stripping on my very old windows. Probably 25+ years old. Any recommendation would be helpful. thank you.

Th bulb strip flat aide is 1/4 inch the bulb is about 3/8 inch. Play need the vinyls rail guide it slides jnto

Found manufactures drawing for insulation used on my casement windows. They listed you as one of their dealers, and I was wondering if you had this style in stock or should I contact window mfg? Need about 14"

Can't find this bubble and unsure of the felt because it's all smashed & doesn't look like its ina channel

I'm searching for a replacement for screen splines off my patio, it's an aluminum frame, like a pool enclosure (see pics) the spline is flat, Tshapes, with a bulb at the bottom of the T. A round spline if .165 fit very tightly, but did not completely full the channel with the screen under it. I thin ... (cont.)

Any sugestion for this window seal