Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

I am looking for a replacement for my sliding door. Do you carry this weather stripping?

Please advise if this material was white to begin with or gray as it shows now

Hello, I am looking to replace the bubble seal on my casement windows. I have looked on your site but have not found the exact replacement. The "bubble" is approx 3/8 diameter and the insert into the window is 1/4" - 5/16". I have seen so.e that are close but the part that holds the seal in place ar ... (cont.)

Glass stop on a slider window, the windows have no manufacture name or date.

They're series 5520 C-C20/C-C40? I've attached photos of the channel the seal slides into and measurements of the seal.

Anybody recognize this profile?

looking for rubbergasket that seals door to threshold

i found couple option but too small to fill the gap between the frama and the sash

Looking to find replacement sesls for my windows. I'm the homeowner and a hvac contractor

Not sure the brand of door but need this weather stripping does it look familiar?

Hi, I can't seem to find this type of weatherstripping anywhere. Do you have this exact replacement? I am looking for 2 pieces, each 26 cm long. it will slide right back into the bottom of my push down/push up window. Can you please help? Let me know if you need more measurements. ... (cont.)

Winguard 954717-00-002 patio door. Dimensions: Base width: 5/32 Height: 3/16 Base extension: 1/16

The attached photos are of a sliding patio door seal, for the track on the bottom of the door. I cannot find any marking for manufacture of the door. It is a 2 piece setup, the rubber seal and the top slide that holds it in place.

This is trim from the outer side of the casement window of a certainteed window that cracked off and needs to be replaced.

1/4" x 1/4" foam sq with white plastic film(?)covering. The wood slot is 1/4" wide to accept with foam piece. The slot is 33 7/8" wide (actual tape measure of bottom of wood frame). The foam piece is also lightly glued in the slot. I need to replace the weatherstripping in 5 identical windows. In t ... (cont.)

Hello, I have a weatherstripping seal for the bottom of the window. The backer of the seal width is about .4-.42”, the channel in the window it rides in is about .372" and .320" deep. It is a simple shape, but I can't find a similar type. Thanks

Window seal that slides into bottom of window. I also have a bathroom window that have moisture build up on the inside glass.

I am looking to replace all of the weather seal. Do you have this type? See photos . The bubble measures 1/2". tyvm! Ali

need about 80 lf

Hi - the door has two sets of the same weather stripping. Flat bottom 5/16" wide x a strong 1/32" thick, bubble about 5/16" diameter. Thanks, Steve