Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

Looking for the replacement for rubber gasket on windows . The above sticker was in one window . this gasket doesn't have foam center.

Need a replacement for the metal crank/opener and all metal bars that attach to it and the window itself (pic 2) The metal rail that holds all the pieces and screws into the bottom of the window frame is 9". Also need 2 plastic handles plus the piece that goes around them (like a picture frame, pi ... (cont.)

The gasket or weatherstripping is worn and ripped and needs replaced. It looks like the item slides into a vertical channel.

Need replacement seal for aluminum frame crank operated louvre window installed 1968... could you clarify part number / suiable replacement

Can you help me identify the piece of plastic trim at the bottom of a window Its 1/2 in wide and 32 in long and it clips into place

Older NUAIR window bottom weather strip

I want to make sure Im getting the correct seal. I have 15 windows most are 35 inch wide

Looking for weather stripping for Norandex windows series 435, 436 SH.

Bottom seal mine is rubber

Thank you for your help. This is a door threshold seal I need to replace, it appears to also be used on the door itself.

I have a piece of foam insulation what was bent out of shape and had to be removed and I'm trying to figure out what to buy to replace it. It snaps into the frame as shown in the photos. Thanks!

Greetings, Our window seals are in dire need of replacement. the home was built back in 2000 and we have no idea of the window mfg name. I have attached a couple pictures in hopes you might be able to assist us in identifying them and/or offering a replacement option. the slot the weatherstripping g ... (cont.)

Good morning, I am seeking assistance to find replacement seals for my windows. Windows were installed as part of new construction in 2016 but are no longer produced. I'm not looking for an exact match to the original but rather an upgrade that will fit the T-Slot groove on the bottom of the sash ... (cont.)

I want to replace the old window weather strip on the screen and bottom sash. I didn't find similar parts on the website. My double hung (tilt) window was installed 2001/8/28. The window tag shows Tee Cee's Home Improvement and has green logo labeled in the lock as "crystal". Any helps on strip like ... (cont.)

Hi, I am trying to identify this bulb weatherstripping. I am hoping that you might be able to match it. Measurements are:Bulb width is 5/16".Bulb height is 4/16". Height of base is 1/8". Width of base is 4/16 to 5/16". Thank you for any help you can offer Anthony

Q-Lon

Good morning, I have original new (2005) construction windows. I need 2 balance blocks 28 B however the lower guide does not look the same in the picture. Also a roll of weather strip ( see pic ) channel looks to be 3/16" - tube appears to be 1/4" Last Glazing see pics 7/8" total width. Thes wi ... (cont.)

I want to replace my window channel seal. The seal has a 0.25" wide flange for sliding into the window groove. The height of the seal is difficult to measure as it has taken a set but is approximarely 0.25". The seal fits a 24" wide window. Pictures are attached.

I don't see the seals on your site. Could you assist and let me know if you have them? They are rubber. Look like 1/4? they are on the bottom of a certainteed window. There are no serial or part numbers on the windows themselves.

I am trying to find a substitute for these two types of weather stripping for our Milgard Tuscany style windows purchased in 2009. Milgard no longer makes this weather stripping. Thank you.