Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

I am look for similar bottom jalousie window frame seal. What I have is broken and brittle.I have attached a picture and will need 27'Thanks, Mark

Need exterior weather stripping to fit T-channel

I need this bulb seal. What size is it. The slotted bottom is 3/16 and diameter is approximately 1/4 maybe bigger

I need to replace a broken Caldwell block and tackle for the subject window identification on the broken on shows Caldwell 28-3 EN. Could you please let me know the replacement Block and Tackle to order

I would like to replace all this base trim on all of my windows. I have not found it yet to just slide out the old and slide in the new seal.

T-slot width is 1/8 of an inch...bulb size is 1/4 inch or slightly larger (5/16 would work).

I'm having a hard time locating this window weather stripping at a store. I think it's called T-hollow offset. Can I still get this type of weather stripping? If so, where?

Looking to replace damaged weatherstripping for certainteed windows installed approximately 1995.Pictures attached. I can send measurements if you have this type available.ThxJoe

Looking for this seal. It has a T shaped part that slides into the channel. The seal is foam filled vinyl covered. It is similar to your 58-200 seal except that the mount is T shaped and not kerf. The T measures 3/16".

Rollers and bottom weatherstrip for 1986 era Old Castle patio doors. Rollers have metal wheel, 1 1/8" diameter. Housing is 2 11/32" long and 19/32" wide and 1 1/16" tall. Weatherstrip (one each side on bottom door frame is 46 1/4" long and has 9/32" wide plastic strip to slide into rail. Unable to ... (cont.)

Hi, I've got some older Nuprime vinyl windows and I'm looking for replacement seal for them. After looking at your site, I believe the closest looking match is your 58-135 Bubble seal (3/16" x 11/32"). This t slot however, doesn't appear to be a perfect match, as the slot part on my current seal ... (cont.)

What weather stripping product do I use here? When door closed, what weather striping is used to seal gap between this jamb and adjacent stationary jamb panel?

This is weatherstripping from a French door, from the stationary side. The house is about 30 years old and it's a 96 inch door. The bubble measures 1/2 inch or 5/8 of an inch. I suspect it started out as 5/8 of an inch. Even if the bubble was three quarters, that would be fine. The width of the ... (cont.)

Your 58-134 looks close to what I'm looking for but the bulb is too small. Do you have something with a larger bulb? Thanks Bob N

Do you carry this weatherstripping. House was built in 1995 Norandex window. Please let me know. Thank you. Lily

I've included the measurement in the picture. Please let me know if you have something equivalent to it.

Hello, I'm trying to track down a new weatherstrip for a metal threshold for a door. The length is 6' minimum and seems to be about 3/8" wide at the tube and 1/4" wide at the T of the rubber that is inserted in the channel. Do you know what it is called or a part number? Do you sell this particular ... (cont.)

Hi, I have several Simonton casement windows with deteriorated weather stripping. The plastic T is 3/16" wide. The bulb is fully filled with foam and is 1/4" wide. Info of the window sticker is as follows: 2 WH FS FE O4 LH C0170 M17 3260296/02

I do not know the make or the model number of this skylight. It's probably 35 to 40 years old.

The seals are for the outside weather trackBase track is 3/8" wide with 3/32 tube attached.The grey foam is attached to the tube.Grey foam is 1/4" thick air hollowed.Any suitable sub that would work with the base track would be great.I have 11 windows that I need to replace the outside seal. Thanks, ... (cont.)