Viewing all customer Discussions for:

59-058 Sliding Screen Door Bug Flap, 8'

Customer needs to replace the weather stripping in his door.

Attached are pictures (best that I could get, sorry) of the screen weather strip / bug shield (?) that I am needing to replace. It is on one side of the screens. The label is the most clear one that I have. Thank you for the help as I cannot find anything close online. If you need anything else to h ... (cont.)

Hello!I am looking for a replacement part for my Pella sliding door. Do you have something like this?Thank you,Courtenay

The strip I am looking to replace is like a vertical sweep that goes into a sliding screen window. At the bottom edge of the piece in the picture where you see my hand, there is a wedge like thing with a hole in it, about a quarter of an inch from left to right, the presses into a channel in the s ... (cont.)

Greetings, I recently purchased a replacement strip of bug flap for my sliding screen door. I ordered p/n 59-058 which has and 11/32 wide fitting strip with total width of 13/32 including the barbs. That width is just a fraction too small for the channels on my door, as the strip fits very loosel ... (cont.)

These are old doors (house built in 1993) and I need the rubber that fits into slot to be 3/8 inch wide. I tried one that just dropped out. I think it was a quarter inch and was too small. I have four sliding screen doors and need your help. Thanks, Hilary

Need the weather stripping for a sliding screen door in white preferably.

Hello, I need help. Pics 1,2 and four illustrate the leaf strip needed to match the old for a sliding screen/storm door. The width of the groove is 3/8". Will need 8' Pic 2 are the old rollers that came out of the frame. The only ID found stamped on the wheel housing was "Part No. 3090084". the w ... (cont.)

Do you sell a Peachtree screen door seal? This is the seal that runs the full height of the door. The door is about 45 years old. The pictures that I will attach show the PD emblem on the door handle and an end view of the channel that the seal fits in.

You guys are great. I've attached a photo of my original flap side by side with the new flap 59-054. The bug flap push-in portion won't stay pushed in (5/16" push-in portion matches the width of the slot in my screen door, 5/16"). Hope you can recommend something. Meanwhile, I'll return the one ... (cont.)

Hi: The diagram shows the total width of the bug strip, and the channel width, but what is the depth of the channel insert? Thanks