Viewing all customer Discussions for:

40-209 Larson Storm Door Sweep

I have older sliding glass doors. I need to replace the weather seals but I am having issues identifying the correct parts. The one seal is a bubble type that fits into a tee slot, it seals the door along the tack, top and bottom. The nominal dimensions are, the tee slot mount on the seal is .187", ... (cont.)

The marking on the door says "legance 3 patio door, type DDSG, code TRI - K - 36". The part is basically a rubber T that slides into the bottom of the door frame with the long leg fitting into a groove in the door frame.

Do you have this strip?

I am in need of a shower sweep,or some kind of suggestion to take care of water running out under the shower door. I do not have a make or an old sweep. Thank you!

I need a replacement vinyl sweep for my storm door. I have tried replacing, but the 1/4" T is too small for the slot and can't seem to find anything with a larger T. I have measured the slot to be either 5/16" or 3/8" Tristan

Part no. 40-209 looks to be a rubber insert. Do you have the metal track that it slides in?

whats the difference between 40-209 and 40-207 door sweep?

All I'm looking for is a 36 inch long piece of rubber weatherstripping to slide into this channel at the bottom of the storm door on a Pella storm door front door combination. This door was installed late 2015 early 2016 so it's not that old. The weatherstripping sits on the exterior side of the doo ... (cont.)

Have been unable to find a weatherstrip to replace the one on our Pella storm door even buying Pella product from Lowe's where we bought the door. Can you advise on what we should get to replace the rubber strip on the bottom of our storm door?

I need a rubber sweep for Pella rolscreen storm door. It is a double sweep in a single channel. The sweep is 36 inches. The interior dimension of the channel looks like 1/4 inch, although it is hard to measure. What rubber sweep do you recommend? Photo attached.

I need bottom sweep for a pella storm door. It is a "T" shaped vinyl extrusion 37" long and the top of the "T" is 3/8" wide and is approx 1" high. All I seem to find on line are sweeps that are approx. 1/8" wide at the top of the "T".

The notch the sweep slides into is 3/8 inch wide, the channel 39 9/16 in width. The hanging down part of sweep measures 9/16 or could be 1/2--hard to get a tape on it. What sweep do you recommend. Thank you. LF

Please tell me which sweep you recommend for this door...I cannot recall the manufacturer nor can I find markings on the door. I'm guessing: Larson. 2.5" sweep plate 31.5" door width

Storm door model 248-TL Built 3/10/1998 Registration # 024881U.111980310 Door has two sweeps

I have a white Pella storm door and the black sweep is torn and I would like to replace it. The registered door number is 12209990176. Do you have a replacement part for this door?

looking for a door sweep for door # 34652052E-121130504 is the one you have listed 40-209 the right one? are thes pts under warranty? door is yr old.

I purchased a Columbia sunset security screen door from Lowes about 4 years ago. I understand these doors are now made by Larson. On the bottom of the door is a rubber slide in

I am having trouble replacing the rubber weather stripping to this door. Registration number 0731970028 141 Also if you have key replacements for the handle Lock Emtek 322 if that is available also. Thank you

I purchased the Larson Storm Door Sweep #40-209 and it is too short....does not cover the bottom of the door where it meets the floor. I need a sweep like the 40-209 to be 3/4 inch wide. Do you have one. Thank you.