Viewing all customer Discussions for:

40-209 Larson Storm Door Sweep

Barb width: 0.125 in. Cap width: 0.375 in. Slot in door: 0.250 in. Single flexible fin Door is vinyl with an aluminum frame Do you have a part that will fit.

I own a Sugar Creek storm door that needs new rubber sweeps fopr the bottpm, none of the hardware or big box stores in my area carry any. Can you lead me where I can purchase?

About 3/4" total depth weather barb and 3/8" top width

Have a 36" survivor storm door that needs new rubber strips on sweep. Have been having trouble finding one that fits. Can U help?

Good day, looking for the seal in the picture. It's a tee seal 1/16 by 9/16

My sliders have this t shaped weather stripping that fits in the grooves on the frame. The stripping tee is 7.9 mm. The fin is about 1 inch high. I have not been able to find it anywhere or find a solution to put 8n its place. Any help would be greatly appreciated.

This door sweep is taller than anything I see here. 1 1/4" tall with about 3/8" insert. Door is nominal 36" wide. Any recommendations would be appreciated. Numbers on the hinge side 14606082-122170814

Hello,I am looking for a weatherstrip that is 1/4 inch wide. I only see 3/16 inch on your website. It does not have to have the 3/8 rubber, the brush type with be sufficient, although ideally we would like it 3/8 inch as well. Please let me know if you can help! Thank you,Troy Senior Maintenance ... (cont.)

I am in florida and my sliders rubber weather striping need replacing. it need to be tucked into a tight track on both sides of the door.

I just need the slide in rubber seal that fits in the channel on teh bottom of the door that has a Dove Tail fit. Door # 90866 271 0908 25

My front door lets in a lot of light and air. I have tried a couple of weatherstrips, but none of them fit the slot in the door. They are double doors, the door that locks in place has an extra black attachment (guessing it is called an astragal) that has a T shaped slot for the weatherstrip to inse ... (cont.)

There are two of these that are 47 1/2". He ordered Larson doors at the same time, but can't remember if this one is a Larson 5/8" from top to bottom and 1/4" across. T shape. Thanks so much

Need Sandstone color retainer strips and Replacement Emtek 322 handle for what I think may be a Chambers brand door. Was installed around 1993, not certain. What color would the handles be available in? retainer strips as follows. 2 at 32" and 2 at 74"also need two rubber sweeps. They have a narro ... (cont.)

Please help to locate, Replacement sweep or extender one or both

I need a single Larson door sweep to fit my door. Attached are pictures of what I need.

Hello, need to order storm door sweep for a Pela store door along with the pile weather stripping.I believe the sweep is 3/8.

Manufacturer unknown. Only markings on door edges were hand written numbers 11 (underlined) then 276. Sweep top is dome shaped 3/16" wide and 3/8" high from top of dome to bottom. I measured the channel which is the same 3/16" wide or maybe 7/32" max.

35004032

Need replacement door sweep for Larson Manufactoring Company Storm door model # 14604031

Looking for replacement sweep to fit the channel in the pic. Top is 3/8" wide and gap to threshold is 5/8" long. Thanks Dan